Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > Search Forums


Showing results 26 to 50 of 71
Search took 0.08 seconds; generated 74 minute(s) ago.
Search: Posts Made By: Ben370
Forum: Engine & Drivetrain 10-18-2021, 12:48 PM
Replies: 20
Views: 3,451
Posted By Ben370
When I drained my oil, it was fine. Normal...

When I drained my oil, it was fine. Normal contaminant free dark brown used oil. I have a magnetic plug and nothing on there or in the filter. I'm just going to assume loose gallery screws and worn...
Forum: Engine & Drivetrain 10-18-2021, 10:50 AM
Replies: 20
Views: 3,451
Posted By Ben370
Z1 makes it and it's in my cart. Thanks

Z1 makes it and it's in my cart. Thanks
Forum: Engine & Drivetrain 10-18-2021, 09:44 AM
Replies: 20
Views: 3,451
Posted By Ben370
So Z1 gallery gasket kit, timing kit including...

So Z1 gallery gasket kit, timing kit including tensioners, timing seal kit, water pump, and thermostat? Anything else I should change while I'm in there? Serpentine belt, tensioner and AC compressor...
Forum: Engine & Drivetrain 10-18-2021, 07:44 AM
Replies: 20
Views: 3,451
Posted By Ben370
On page LU-13 At 176F: 14psi+ idle, 43psi+ 2k...

On page LU-13
At 176F: 14psi+ idle, 43psi+ 2k rpm
Obviously 5W-30 is Nissan's recommended weight, which I use.

And it says pressure is higher when cold, so mine is really bad since it was 12psi...
Forum: Engine & Drivetrain 10-17-2021, 07:02 PM
Replies: 20
Views: 3,451
Posted By Ben370
Yeah I already knew it's super low just wanted to...

Yeah I already knew it's super low just wanted to know what to check first.

I made a tee fitting quick disconnect (https://imgur.com/cGCAwiK) so I could add a gauge inside the car later on. Hooked...
Forum: Engine & Drivetrain 10-17-2021, 03:27 PM
Replies: 20
Views: 3,451
Posted By Ben370
Low Oil Pressure

I just changed my oil so I figured I check the pressure just in case. It starts at 20psi and works its way to 12, and that's before it even warms up.
I guess that explains the revs dropping a bit...
Forum: Parts for sale (Private Classifieds) 09-18-2021, 08:53 PM
Replies: 0
Views: 909
Posted By Ben370
Z1 Rear Diff Bushing Tool

SOLD

One of the big nuts is slightly worn but you can put that in the grooved ring anyway. No grease included. $60 continental US only
...
Forum: Nissan 370Z General Discussions 09-10-2021, 10:06 PM
Replies: 6,545
Views: 772,822
Posted By Ben370
Installed Whiteline diff bushings. Had I known...

Installed Whiteline diff bushings. Had I known they would be seized in place and take many hours just to remove, I would've brought it to a shop.
Forum: Nissan 370Z General Discussions 07-30-2021, 11:15 AM
Replies: 6,545
Views: 772,822
Posted By Ben370
Oil change Pushed my new radiator hose on...

Oil change

Pushed my new radiator hose on the rest of the way to stop a leak that would happen at high revs and cleaned the green mess it made in the engine bay (side tangent: whoever at Nissan...
Forum: Nissan 370Z General Discussions 06-18-2021, 03:24 PM
Replies: 6,545
Views: 772,822
Posted By Ben370
Changed my coolant, radiator hoses, belt, and...

Changed my coolant, radiator hoses, belt, and tensioner.
Forum: Engine & Drivetrain 05-10-2021, 06:58 PM
Replies: 5
Views: 1,824
Posted By Ben370
Follow-up: I ended up putting it back since I had...

Follow-up: I ended up putting it back since I had to go back in there anyway.
Forum: Engine & Drivetrain 04-22-2021, 11:06 PM
Replies: 2
Views: 1,061
Posted By Ben370
I only asked for the bleed, not troubleshooting...

I only asked for the bleed, not troubleshooting so I didn't get charged since he didn't fix it.

Update: asked mechanic and he was saying the leak was with the bleeder threads so getting a new...
Forum: Engine & Drivetrain 04-22-2021, 09:48 PM
Replies: 2
Views: 1,061
Posted By Ben370
Shifting problems after transmission replacement

I changed transmission, clutch, pressure plate, flywheel, pilot bushing, master cylinder, ZSpeed CSC, short shifter, and had it bled again.
After bleeding, shifted nice for a few minutes but tough...
Forum: Nissan 370Z General Discussions 04-20-2021, 08:51 PM
Replies: 6,545
Views: 772,822
Posted By Ben370
Removed my rusted cat studs with a ball joint...

Removed my rusted cat studs with a ball joint tool and replaced them with nuts and bolts.
Forum: Brakes & Suspension 04-08-2021, 01:03 AM
Replies: 199
Views: 147,357
Posted By Ben370
So Motul RBF 600 on a daily street car, still...

So Motul RBF 600 on a daily street car, still overkill? I got a 2 pack for $32 and changed my fluid the other day. Should I go with 1 or 2 years in between changes and possibly switch to DOT 3?
Forum: The Lounge (Off Topic) 03-01-2021, 06:07 PM
Replies: 10,010
Views: 565,097
Posted By Ben370
Got a new tire for my donut since it was original...

Got a new tire for my donut since it was original and probably never used (wheel still shiny). Yokohama Y870C
Forum: Engine & Drivetrain 12-28-2020, 11:35 AM
Replies: 5
Views: 1,824
Posted By Ben370
Even then, the hooked fitting on the trans should...

Even then, the hooked fitting on the trans should be enough right? Isn't that whole setup just in case you drive through water or something? And at that water level your intake would be sucking in...
Forum: Engine & Drivetrain 12-28-2020, 10:44 AM
Replies: 5
Views: 1,824
Posted By Ben370
Forgot to install breather tube bracket when changing transmission

I put the tube on the transmission but after finishing realized I didn't put the tube bracket on the top mount bolt.

It should be fine, right? Functionally, it still should vent the way it should...
Forum: Engine & Drivetrain 02-10-2019, 11:53 PM
Replies: 2
Views: 3,704
Posted By Ben370
AC Compressor Clutch Wiring?

The other day my car was stalling and I realized it was the AC clutch since it was smoking and melted. Turned off AC and it was fine. AC clutch won't turn back on though, just a click when I press...
Forum: Engine & Drivetrain 12-14-2018, 02:37 PM
Replies: 3
Views: 1,349
Posted By Ben370
Reusing CSC when changing the transmission?

I put in a new clutch kit, Zspeed CSC, and master cylinder early last year.

Now it's rough going into gear and the rear section of the trans has a small leak so I know that's bad.

The service...
Forum: Parts for sale (Private Classifieds) 02-04-2018, 02:33 PM
Replies: 26
Views: 4,138
Posted By Ben370
PM sent

PM sent
Forum: Parts for sale (Private Classifieds) 01-08-2018, 03:24 PM
Replies: 2
Views: 954
Posted By Ben370
Is this what you're talking about? ...

Is this what you're talking about?

https://i.imgur.com/VHna9zE.jpg
Forum: Parts for sale (Private Classifieds) 01-08-2018, 01:43 AM
Replies: 0
Views: 907
Posted By Ben370
Fast Intentions Lead Pipes with 100 Cell Cats

http://www.fastintentions.com/images/100_cell_cats.jpg

Will trade for normal lead pipes
Forum: DIY Section (Do-It-Yourself) 11-13-2017, 01:29 AM
Replies: 7
Views: 5,991
Posted By Ben370
Door & Lock: DLK-214 It refers you to the...

Door & Lock: DLK-214
It refers you to the Interior manual as well.
https://i.imgur.com/0x8SQXA.pnghttps://i.imgur.com/ifz2jPy.png
Forum: Wheels & Tires 11-10-2017, 11:59 AM
Replies: 17
Views: 6,474
Posted By Ben370
Went with Sport Edition A9's 18x8 +35mm and...

Went with Sport Edition A9's 18x8 +35mm and 225/50R18 Blizzak WS80's. Test fit them today. Of course they took a little wiggling to get them on as I'm used to the extra room with 19" wheels....
Showing results 26 to 50 of 71

 
Forum Jump

All times are GMT -5. The time now is 03:03 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2