Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > Search Forums


Showing results 26 to 49 of 49
Search took 0.01 seconds; generated 68 minute(s) ago.
Search: Posts Made By: Mn23
Forum: Track / Autocross / Drifting / Dragstrip 04-28-2020, 05:40 PM
Replies: 15
Views: 3,274
Posted By Mn23
Yes I meant square setup. 275/35/18 vs 305/35/18

Yes I meant square setup. 275/35/18 vs 305/35/18
Forum: Track / Autocross / Drifting / Dragstrip 04-28-2020, 03:59 PM
Replies: 15
Views: 3,274
Posted By Mn23
Track tire size

Hey guys, after some research seems like a lot of track guys suggest 275/35/18 because of the wide availability. Is there any disadvantages going 305/35/18 on my NA Z with 10.5” rim? Slows down the...
Forum: Track / Autocross / Drifting / Dragstrip 04-04-2020, 09:09 PM
Replies: 327
Views: 42,830
Posted By Mn23
What kind of front camber is needed to run 18x11...

What kind of front camber is needed to run 18x11 +18?
Forum: Brakes & Suspension 08-21-2019, 03:42 PM
Replies: 53
Views: 8,878
Posted By Mn23
I don’t know what you are trying to imply but I...

I don’t know what you are trying to imply but I just bought a set of Z1 rotors that was why asking if the calipers will fit with Z1 rotors
Forum: Brakes & Suspension 08-20-2019, 07:05 PM
Replies: 53
Views: 8,878
Posted By Mn23
Thanks the info. I was going to get XP10 and XP8...

Thanks the info. I was going to get XP10 and XP8 to try like most people suggested but also want to upgrade the brakes as I found a deal that I don’t want to pass on...
Forum: Brakes & Suspension 08-19-2019, 12:45 PM
Replies: 53
Views: 8,878
Posted By Mn23
Another question I have is, am I be able to use...

Another question I have is, am I be able to use the Z1 2 piece rotor on a AP/Stoptech caliper? Reason is I can get the 6 pot calipers alone without their rotors.
Forum: Brakes & Suspension 08-19-2019, 12:23 PM
Replies: 53
Views: 8,878
Posted By Mn23
Yes it’s a track car, the OE Akebonos with Hawk...

Yes it’s a track car, the OE Akebonos with Hawk HTC pads are triggering ice mode too much. Hence, looking to upgrade AP or Stoptech Trophy 6 piston kit. Ideally with 355-362mm for my 18’s.
I am...
Forum: Brakes & Suspension 08-19-2019, 06:58 AM
Replies: 53
Views: 8,878
Posted By Mn23
I see. Was thinking to get the 6 piston front BBK...

I see. Was thinking to get the 6 piston front BBK and possibly move the OE 4 piston to the rear lol...

Will the OE 2 piston rear be fine then with the BBK 6 up front? Track use wise
Forum: Brakes & Suspension 08-18-2019, 11:02 PM
Replies: 53
Views: 8,878
Posted By Mn23
Sorry a dumb question...can the 4 pot Akebonos...

Sorry a dumb question...can the 4 pot Akebonos fit in the rear?
Forum: Brakes & Suspension 08-13-2019, 06:27 AM
Replies: 53
Views: 8,878
Posted By Mn23
Thinking of getting the Brembo 6 pot upgrade too...

Thinking of getting the Brembo 6 pot upgrade too but according to Mike who had them installed said they are not well balanced (with the OE rears) for the track? And not all 18s will clear...
...
Forum: Track / Autocross / Drifting / Dragstrip 06-16-2019, 07:54 PM
Replies: 25
Views: 5,065
Posted By Mn23
Yes I am planning to raise the height a bit as it...

Yes I am planning to raise the height a bit as it is quite low. My spring rates are quite stiff at 20k front and 18k rear. Should I set the rears height a bit higher than the fronts?

My rear...
Forum: Track / Autocross / Drifting / Dragstrip 06-15-2019, 09:37 PM
Replies: 25
Views: 5,065
Posted By Mn23
I have divorced setup in the rear, will lessen...

I have divorced setup in the rear, will lessen the camber in the rear to around -2 first.

Thanks Rusty, I’m currently at +6 caster, is there any cons for going +7?
Forum: Track / Autocross / Drifting / Dragstrip 06-15-2019, 06:09 AM
Replies: 25
Views: 5,065
Posted By Mn23
Thanks, so checking tire temps across the tire is...

Thanks, so checking tire temps across the tire is the key. Should the outside be hotter? I was trying some used 305 slicks all around and the front were close with the inside being a tad bit hotter...
Forum: Track / Autocross / Drifting / Dragstrip 06-14-2019, 11:16 PM
Replies: 25
Views: 5,065
Posted By Mn23
Track Alignment

Hey guys, I’ve searched through the board and seems everyone is running less than -3 degrees camber up front and -2 rear for track. My alignment shop however recommended -3.7 front and -3.0 rear on...
Forum: Track / Autocross / Drifting / Dragstrip 06-19-2018, 07:44 PM
Replies: 13
Views: 2,857
Posted By Mn23
Thanks Rusty and all. I took the pads out to...

Thanks Rusty and all.
I took the pads out to inspect and they look fine, bleed the brakes again. I’m also fabricating some cooling deflectors that ties on the rods to direct more air to the front...
Forum: Track / Autocross / Drifting / Dragstrip 06-19-2018, 12:09 PM
Replies: 13
Views: 2,857
Posted By Mn23
No I am not at all a skilled driver, just the...

No I am not at all a skilled driver, just the setup on the Z is quite nice to drive. I had a 350Z as track car before with similar setup but didn’t have these brake issues.

Thanks Rusty, I even...
Forum: Track / Autocross / Drifting / Dragstrip 06-19-2018, 10:15 AM
Replies: 13
Views: 2,857
Posted By Mn23
I’m actually running RE71R before and now Pirelli...

I’m actually running RE71R before and now Pirelli slicks with a lot of grip. Weather was pretty cool so I didn’t have anything heating issues. Just didn’t get why the ABS is acting up, car is brand...
Forum: Track / Autocross / Drifting / Dragstrip 06-19-2018, 07:21 AM
Replies: 13
Views: 2,857
Posted By Mn23
Thanks guys, my pedal never went to floor or soft...

Thanks guys, my pedal never went to floor or soft that’s why I thought it wasn’t fading. The pedal did go stiff (but not solid hard i guess) and ABS pulsing for sure when I brake harder before the...
Forum: Track / Autocross / Drifting / Dragstrip 06-18-2018, 10:02 PM
Replies: 13
Views: 2,857
Posted By Mn23
Ice mode braking

Sorry guys I have been searching and reading a lot of the older posts but still can’t find the best way to cure ice mode on the track. Investng in a race abs controller is not an affordable option...
Forum: Track / Autocross / Drifting / Dragstrip 09-06-2016, 09:12 PM
Replies: 13
Views: 3,026
Posted By Mn23
Thats what I thought too, but according to SPL...

Thats what I thought too, but according to SPL toe bolts are prone to slip if you track the car. Any one experience this slippage issue?
Forum: Track / Autocross / Drifting / Dragstrip 09-06-2016, 03:33 PM
Replies: 13
Views: 3,026
Posted By Mn23
Thanks guys. Just that I didn't expect this much...

Thanks guys. Just that I didn't expect this much $$ for rears...

For those of you with other brands like SPC, Kinetix, Z1 etc., they don't offer the mid links like SPL so are they good enough for...
Forum: Track / Autocross / Drifting / Dragstrip 09-06-2016, 01:23 PM
Replies: 13
Views: 3,026
Posted By Mn23
I'm trying to get SPL all around but am confused...

I'm trying to get SPL all around but am confused on which ones to get for the toe. I have the divorced setup in the rear.

Rear camber arms
Rear toe arms (made for true setup)
Rear toe bolts...
Forum: Canada 08-03-2016, 09:40 PM
Replies: 16
Views: 3,918
Posted By Mn23
Mind me asking where you order and how much the...

Mind me asking where you order and how much the lip costed you?
Forum: Canada 08-02-2016, 02:24 PM
Replies: 0
Views: 1,101
Posted By Mn23
FS: Brand new in box ST front and rear sway bar set

Selling for a friend who sold the car before putting them on. Still brand new in box Suspension Techniques front and rear sway bar set. $400
Showing results 26 to 49 of 49

 
Forum Jump

All times are GMT -5. The time now is 02:22 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2