Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > Search Forums


Showing results 1 to 9 of 9
Search took 0.00 seconds.
Search: Posts Made By: fillerbunnie
Forum: Forced Induction 08-07-2016, 12:55 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
So, just did the following: - cleaned TB's -...

So, just did the following:
- cleaned TB's
- cleaned MAF's
- reset TBs, ECU and idle air volume

No change, still crippling ECU mode

I then replaced the MAP sensor with a voltage divider...
Forum: Forced Induction 08-06-2016, 03:17 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
Update: Still F***ed. I'm certain it's...

Update:

Still F***ed.

I'm certain it's the MAF/MAP sensor...

Sam at GTM was useless, as was Uprev. Basically I'm physically limited by not being able to disable this code.

The original...
Forum: Forced Induction 05-24-2016, 05:51 PM
Replies: 28
Views: 3,844
Posted By fillerbunnie
Sorry, I should clarify - It has been...

Sorry, I should clarify - It has been significantly modified, but the starting point was the GTM base tune. AFR targets are fine and timing is conservative.
Forum: Forced Induction 05-24-2016, 04:59 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
OK, so I disconnected the MAP sensor and the ECU...

OK, so I disconnected the MAP sensor and the ECU throws P010A. I have no P010B, but I do have P010A,C,D.

With the MAP sensor disconnected, I get full boost followed by crippled performance shortly...
Forum: Forced Induction 05-23-2016, 06:52 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
I've just grabbed all the Uprev ECU dumps for...

I've just grabbed all the Uprev ECU dumps for EU/AUS models (I'm 1EL6B, but I downloaded all the others with the rom editor) - They are all missing 101, 106, in fact all the MAF & MAP...
Forum: Forced Induction 05-22-2016, 06:32 PM
Replies: 28
Views: 3,844
Posted By fillerbunnie
Ahhhh this looks very promising!! Problem is I...

Ahhhh this looks very promising!! Problem is I don't have P0101 at all :( It's missing from my Uprev rom... Did you have to make any changes to have these options? I don't have the 2 DTC settings for...
Forum: Forced Induction 05-22-2016, 08:32 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
Belt coverage with the GTM kit is very high, the...

Belt coverage with the GTM kit is very high, the belt is in good condition and tension is fine so I think that can be ruled out. PCV is fine as well, unblocked and no leaks.

Supercharger I'm...
Forum: Forced Induction 05-22-2016, 07:46 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
I've removed, torn-down, cleaned, lubricated &...

I've removed, torn-down, cleaned, lubricated & re-assembled the BPV (35mm turbosmart re-circulating). It seems to operate smoothly and normally in response to pressure/vacuum changes. About 6 months...
Forum: Forced Induction 05-22-2016, 06:25 AM
Replies: 28
Views: 3,844
Posted By fillerbunnie
GTM stage 1 S/C - Throttle not opening fully? Or boost leak? Please help!

So more than 2 years after installing a GTM stage 1 S/C, I still am plagued by gremlins.

Basically, cold start performance is excellent. I get on-boost instantly and it pulls like a maniac. After...
Showing results 1 to 9 of 9

 
Forum Jump

All times are GMT -5. The time now is 12:37 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2