Nissan 370Z Forum - Search Results

		Nissan 370Z Forum > Search Forums
Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: phunk

Forum: Forced Induction

07-01-2019, 11:51 AM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

I havent seen the car in a couple weeks, I am not...

I havent seen the car in a couple weeks, I am not sure where he is at with the front end. I know when this pic was taken there was still more pieces to go back in, but I dont recall anything that...

Forum: Forced Induction

06-29-2019, 08:47 PM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

There seems to be no photos really of the build...

There seems to be no photos really of the build here. This is a semi-recent photo. The hood does shut, and has no holes in the hood skin. The underside has a bunch of stuff cut out though to clear...

Forum: Forced Induction

06-29-2019, 08:38 PM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

Ya a lot of effort was wasted looking at the...

Ya a lot of effort was wasted looking at the hydraulics since that is usually the culprit when there are clutch problems on this platform. But Justin replaced the whole system and there was zero...

Forum: Forced Induction

06-29-2019, 07:05 PM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

The car runs but currently cannot drive due to a...

The car runs but currently cannot drive due to a clutch problem. The components are too warped to allow disengagement. The car sits awaiting clutch rebuild components from OSG.

Forum: Forced Induction

02-09-2019, 10:39 PM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

For what it’s worth, the stock VQ fasteners spec...

For what it’s worth, the stock VQ fasteners spec is 30# + 190 degrees (95 + 95).

That’s 80 degrees more rotation in the VR fastener over the VQ. They are both 1.25mm thread pitch, so that...

Forum: Forced Induction

02-07-2019, 12:06 PM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

Stock Nissan bolts are TTY (torque to yield)...

Stock Nissan bolts are TTY (torque to yield) fasteners, thus are not tightened to a torque spec. It is a different type of strategy for fasteners. After a uniform 30# is set they are tightened an...

Forum: Forced Induction

02-06-2019, 10:49 PM

Replies: 51

CJM (Justin's) drag build

Views: 8,400

Posted By phunk

Justin's car isn't expected to run well into...

Justin's car isn't expected to run well into spring 2019. There is a lot of fabricating that needs to be done to build the custom intercooler and piping system, along with a custom coolant expansion...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -5. The time now is 06:59 PM.