Nissan 370Z Forum - Search Results

		Nissan 370Z Forum > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: roy'sz

Forum: DIY Section (Do-It-Yourself)

05-09-2013, 02:35 PM

Replies: 254

Sticky: DIY: Finally Installed The STILLEN G3 Intake today! Lots of Pics inside (AK370Z)

Views: 134,291

Posted By roy'sz

I used a sharpie to mark where the rubber needed...

I used a sharpie to mark where the rubber needed to go and used electrical tape to sleeve the tube. I also ziptied tje tubes to the crash bar to make it easier to install the front fascia.

Forum: DIY Section (Do-It-Yourself)

05-08-2013, 11:34 PM

Replies: 254

Sticky: DIY: Finally Installed The STILLEN G3 Intake today! Lots of Pics inside (AK370Z)

Views: 134,291

Posted By roy'sz

I did....the pipes do pulse so you could hear a...

I did....the pipes do pulse so you could hear a resonating sound through the car. I wrapped mine with rubber at the support beams.

Forum: DIY Section (Do-It-Yourself)

02-04-2013, 12:25 AM

Replies: 254

Sticky: DIY: Finally Installed The STILLEN G3 Intake today! Lots of Pics inside (AK370Z)

Views: 134,291

Posted By roy'sz

Also thought I might add, it would be useful to...

Also thought I might add, it would be useful to pur your wipers at top center and shut the carr off so you can get plastic panel off to gain access to rear mounting bolts on strut brace. Just a fyi...

Forum: DIY Section (Do-It-Yourself)

02-03-2013, 06:12 PM

Replies: 254

Sticky: DIY: Finally Installed The STILLEN G3 Intake today! Lots of Pics inside (AK370Z)

Views: 134,291

Posted By roy'sz

Thats why I have a $14 diegrinder and air...

Thats why I have a $14 diegrinder and air compressor with burr bits. Easier than grading cheese!

Forum: DIY Section (Do-It-Yourself)

02-02-2013, 08:32 PM

Replies: 254

Sticky: DIY: Finally Installed The STILLEN G3 Intake today! Lots of Pics inside (AK370Z)

Views: 134,291

Posted By roy'sz

I I stalled mi e today using a burr bit on my...

I I stalled mi e today using a burr bit on my diegrinder....made cutting a whole lot faster. Both holes modified in approx. 3min. All in all 2hrs for install. Forgot to put my stirafoam bumper on.

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -5. The time now is 08:21 AM.