Nissan 370Z Forum  

370Z Forums HOME My Picture Album Nissan 370Z Pictures Premium Membership Become a Forum Sponsor
Go Back   Nissan 370Z Forum > Search Forums
Reload this Page Search Results
Register All Albums FAQDonate Members List Calendar Today's Posts


Showing results 1 to 22 of 22
Search took 0.00 seconds. Search: Posts Made By: Staples
Forum: Forced Induction 07-29-2012, 11:24 PM
Replies: 2,643
Views: 354,952
Posted By Staples
As mentioned before, all kits will get...

As mentioned before, all kits will get heatsoaked. If I've been doing back to back Dyno runs I'll lose 20 - 25whp. If I let the motor (supercharger) cool down for about 10 minutes I'll make the power...
Forum: Forced Induction 12-07-2010, 09:42 PM
Replies: 2,643
Views: 354,952
Posted By Staples
370Z / G37 Supercharger System Progress: Intake...

370Z / G37 Supercharger System Progress: Intake Manifold & Intercooler : STILLEN (http://blog.stillen.com/2010/01/370z-g37-supercharger-system-progress-intake-manifold-intercooler/)

That should...
Forum: Forced Induction 12-07-2010, 11:20 AM
Replies: 2,643
Views: 354,952
Posted By Staples
I won't fight you about that one.

I won't fight you about that one.
Forum: Forced Induction 12-06-2010, 10:43 PM
Replies: 2,643
Views: 354,952
Posted By Staples
Make sure your air/fuel is in check. 10.2psi on a...

Make sure your air/fuel is in check. 10.2psi on a 8psi tune in cold weather can be catastrophic if it leans out too much... then boom.
Forum: Forced Induction 12-06-2010, 08:53 PM
Replies: 2,643
Views: 354,952
Posted By Staples
It's in the works, unfortunately it's easier said...

It's in the works, unfortunately it's easier said then done. The way the piping is setup makes it next to impossible to evenly distribute air to each sensor.
Forum: Forced Induction 12-06-2010, 09:04 AM
Replies: 2,643
Views: 354,952
Posted By Staples
MAF sensor is what we need. If there's any change...

MAF sensor is what we need. If there's any change in voltage or just a small amount of debris that gets on it, the car goes into limp mode. That's how fragile they actually are. Plus they're pretty...
Forum: Forced Induction 12-06-2010, 12:25 AM
Replies: 2,643
Views: 354,952
Posted By Staples
It's the other way around. Drawn through is...

It's the other way around. Drawn through is before the supercharger, blown through is after the supercharger before the throttle-body (Stillen = Drawn, GTM = Blown).
Forum: Forced Induction 12-05-2010, 09:22 PM
Replies: 2,643
Views: 354,952
Posted By Staples
Good point, but if the MAF is reading a certain...

Good point, but if the MAF is reading a certain temperature, lower then what's actually going to go into the motor... there lies a problem. I've heard UpRev has a calibration tool to allow you to...
Forum: Forced Induction 12-05-2010, 07:03 PM
Replies: 2,643
Views: 354,952
Posted By Staples
My mechanic is working on a 3rd MAF sensor (after...

My mechanic is working on a 3rd MAF sensor (after the supercharger, before the throttle-bodies) that could be added, who knows how much of a pain in the *** that's going to be. At this point, even if...
Forum: Forced Induction 12-05-2010, 03:58 PM
Replies: 2,643
Views: 354,952
Posted By Staples
I'd like to use the excuse about different...

I'd like to use the excuse about different elevation and fuel, but I can't. Christian on the 37 forums shipped his car from Maryland to California for his twin build and there hasn't been one issue...
Forum: Forced Induction 12-05-2010, 12:00 AM
Replies: 2,643
Views: 354,952
Posted By Staples
Good luck, hope all goes well.

Good luck, hope all goes well.
Forum: Forced Induction 12-04-2010, 11:41 PM
Replies: 2,643
Views: 354,952
Posted By Staples
Too much fuel, some needs to be taken out....

Too much fuel, some needs to be taken out. Without looking at a wideband it's hard to see where your curves are, unless you're on a dyno. Are you sure your car was knocking, and not just bogging?
Forum: Forced Induction 12-03-2010, 09:55 PM
Replies: 2,643
Views: 354,952
Posted By Staples
It could also be the timing is retarded too much.

It could also be the timing is retarded too much.
Forum: Forced Induction 12-03-2010, 09:54 PM
Replies: 2,643
Views: 354,952
Posted By Staples
Relearn and recalibrate the idle. It could be a...

Relearn and recalibrate the idle. It could be a glitch in the UpRev tune too.
Forum: Forced Induction 12-03-2010, 01:23 AM
Replies: 2,643
Views: 354,952
Posted By Staples
When my MAF sensor wasn't getting the proper...

When my MAF sensor wasn't getting the proper voltages it immediately went into limp mode for approximately 10 minutes. I shut the car off, waited for a few minutes and turned the car back on. I find...
Forum: Forced Induction 11-27-2010, 09:10 PM
Replies: 2,643
Views: 354,952
Posted By Staples
The car has a built in knock sensor to pull...

The car has a built in knock sensor to pull timing if it senses any type of pinging. They've had them on the 350z and G35 too.
Forum: Forced Induction 11-26-2010, 04:33 PM
Replies: 2,643
Views: 354,952
Posted By Staples
$800 for a knock amp is absolutely outrageous. I...

$800 for a knock amp is absolutely outrageous. I can't even listen to music while I'm logging data!
Forum: Forced Induction 10-30-2010, 09:38 PM
Replies: 2,643
Views: 354,952
Posted By Staples
Omfg hot! ^

Omfg hot! ^
Forum: Forced Induction 10-20-2010, 12:34 AM
Replies: 2,643
Views: 354,952
Posted By Staples
How about trying some sort of octane booster to...

How about trying some sort of octane booster to help with the pinging issues? Do you buy gas from the same place all the time?
Forum: Forced Induction 10-20-2010, 12:32 AM
Replies: 2,643
Views: 354,952
Posted By Staples
Both are forms of detonation, so in theory, yes.

Both are forms of detonation, so in theory, yes.
Forum: Forced Induction 09-30-2010, 12:53 AM
Replies: 2,643
Views: 354,952
Posted By Staples
He didn't go full throttle until about 4200rpms...

He didn't go full throttle until about 4200rpms that's why the A/F dipped so low. You want to be at 14:1 when cruising, but it should immediately drop when giving it open throttle 50-100%. Optimal...
Forum: Forced Induction 09-26-2010, 11:48 PM
Replies: 2,643
Views: 354,952
Posted By Staples
:iagree: I've got a reputable installer/tuner in...

:iagree: I've got a reputable installer/tuner in MD if anyone is local to that area looking to get this done.
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -5. The time now is 09:12 AM.

Contact Us - Home Page - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2