Nissan 370Z Forum  

370Z Forums HOME My Picture Album Nissan 370Z Pictures Premium Membership Become a Forum Sponsor
Go Back   Nissan 370Z Forum > Search Forums
Reload this Page Search Results
Register All Albums FAQDonate Members List Calendar Today's Posts


Page 1 of 18 1 2311 Last »
Showing results 1 to 25 of 447
Search took 0.02 seconds. Search: Posts Made By: fryzia23
Forum: Engine & Drivetrain 03-18-2024, 10:05 AM
Replies: 5
Views: 616
Posted By fryzia23
Most likely you got bad fuel in there considering...

Most likely you got bad fuel in there considering it happened right after refuel. I'd get a fuel sample and check it out for water content.
Forum: Wheels & Tires 09-06-2023, 03:59 PM
Replies: 23
Views: 1,630
Posted By fryzia23
Best tire for the money that I had personally,...

Best tire for the money that I had personally, nankang ar1. Very good cold grip, superb at the track. Not so great in the rain but if you want grip thats the way to go.
Forum: Track / Autocross / Drifting / Dragstrip 08-30-2023, 02:11 PM
Replies: 226
Views: 54,786
Posted By fryzia23
New Jersey Motorsports Park Thunderbolt 2011...

New Jersey Motorsports Park Thunderbolt
2011 Nismo Gtm supercharger stg 2, first time on Michelin slicks scrubs, 1:27.62

Garmin footage
https://youtu.be/4ZIQKk_Q7ks?si=NLpkhWl7geHSDo-h
...
Forum: Track / Autocross / Drifting / Dragstrip 07-19-2023, 11:26 AM
Replies: 7
Views: 873
Posted By fryzia23
Track pads squeal and not much you can do about...

Track pads squeal and not much you can do about it. Only thing you can do is to swap street friendly pads to track pads between track days. Also for wheel weights falling off, you can put something...
Forum: Tuning 07-16-2023, 12:23 PM
Replies: 4
Views: 1,117
Posted By fryzia23
It’s in the tune. Too much fuel is dumped during...

It’s in the tune. Too much fuel is dumped during hot starts and that’s why you need to add pedal input to add more air to get it started. Had same issue when went to 1050 injectors. Changed to ecutek...
Forum: Engine & Drivetrain 07-05-2023, 09:06 AM
Replies: 15
Views: 3,860
Posted By fryzia23
that sounds like could be your AC compressor...

that sounds like could be your AC compressor clutch that seized up. The compressor is on the side of the engine. That would explain why the AC went out as well. Good luck
Forum: Track / Autocross / Drifting / Dragstrip 06-07-2023, 05:49 PM
Replies: 226
Views: 54,786
Posted By fryzia23
Blew my motor first track day in early 2021....

Blew my motor first track day in early 2021. Built my own motor but ran into issues and needed to be pulled. Decided to throw in used complete engine for now from 2020 car with 18k miles. First track...
Forum: Exterior & Interior 05-31-2023, 08:43 AM
Replies: 2
Views: 760
Posted By fryzia23
Easy way to make sure your wiring is good without...

Easy way to make sure your wiring is good without going deep with multimeter is to swap and connect the headlights and see if the problem moves from side to side. If it doesnt you know its something...
Forum: Member's 370Z Gallery 02-15-2023, 09:45 AM
Replies: 496
Views: 71,156
Posted By fryzia23
Or another alternative.. befriends some of the...

Or another alternative.. befriends some of the track rats whom are near by where you live, go to the same events, trailer their cars and use them for tire transport!
Forum: Engine & Drivetrain 02-09-2023, 11:31 AM
Replies: 5
Views: 1,203
Posted By fryzia23
I would pull the oil pan before going crazy. If...

I would pull the oil pan before going crazy. If there is no metal then its a good sign the bearings are fine. To me does sound like rod knock. Also to check for rod bearing damage, you can have the...
Forum: Forced Induction 02-05-2023, 06:26 AM
Replies: 145
Views: 23,806
Posted By fryzia23
It’s not that simple, those who have GTM kit know...

It’s not that simple, those who have GTM kit know what I’m talking about. Modified mount already came with the kit to make room for the charger.
Forum: Forced Induction 02-04-2023, 02:19 PM
Replies: 145
Views: 23,806
Posted By fryzia23
The only thing that’s stopping me from going c38r...

The only thing that’s stopping me from going c38r is the need of custom intake pipe. It’s tight as it is and adding another half inch thicker pipe, it would require a lot of custom welding and...
Forum: Forced Induction 02-04-2023, 02:00 PM
Replies: 145
Views: 23,806
Posted By fryzia23
Stage 1.5

Stage 1.5
Forum: Forced Induction 02-04-2023, 07:49 AM
Replies: 145
Views: 23,806
Posted By fryzia23
bump an old thread, I need to to replace my...

bump an old thread, I need to to replace my charger and on the fence whether to go with the R or stick with C38-81 or 91
Forum: Engine & Drivetrain 01-08-2023, 12:51 PM
Replies: 13
Views: 933
Posted By fryzia23
Sounds like your exhaust center pipes are mm away...

Sounds like your exhaust center pipes are mm away from cross brace and touching it under certain conditions. Very common actually, I would check that first
Forum: Engine & Drivetrain 01-07-2023, 08:31 PM
Replies: 19
Views: 2,119
Posted By fryzia23
Have you replaced the relay? Bad relay could...

Have you replaced the relay? Bad relay could cause issues. It would make sense that after few mins of driving it gets so hot causing resistance and it spikes the amperage causing the fuse to blow. I...
Forum: Engine & Drivetrain 11-22-2022, 07:53 PM
Replies: 9
Views: 1,091
Posted By fryzia23
Spooler mentioned it but the OP never confirmed...

Spooler mentioned it but the OP never confirmed it. When you say “stock ecu never tuned”, does that mean the ecu was not flashed with base tune for the supercharger and larger injectors?
Forum: Engine & Drivetrain 11-22-2022, 05:45 PM
Replies: 9
Views: 1,091
Posted By fryzia23
Fuel pump might be priming but do you have...

Fuel pump might be priming but do you have correct fuel pressure at the fuel rail?
Forum: Forced Induction 11-11-2022, 08:30 PM
Replies: 5
Views: 1,130
Posted By fryzia23
I built my bottom end stock crank with BC rods....

I built my bottom end stock crank with BC rods. Both main and rod King standard bearings. According to my plastigauge readings the clearances were on point for both.
Forum: Engine & Drivetrain 11-10-2022, 07:39 AM
Replies: 5
Views: 626
Posted By fryzia23
I would start with radiator fan control module...

I would start with radiator fan control module before I go deep into it. Its fairly cheap.
Forum: Engine & Drivetrain 10-31-2022, 11:04 AM
Replies: 2
Views: 1,280
Posted By fryzia23
Why were the axles replaced?

Why were the axles replaced?
Forum: New Forum Member 10-13-2022, 02:30 PM
Replies: 13
Views: 3,570
Posted By fryzia23
I would change spark plugs as well

I would change spark plugs as well
Forum: Track / Autocross / Drifting / Dragstrip 09-17-2022, 07:20 PM
Replies: 20
Views: 1,994
Posted By fryzia23
With track alignment, driving straight on the...

With track alignment, driving straight on the highway can wear the inside of tires really quick. My tires would look the same when I drove to the track and back. Probably the addition of negative...
Forum: Engine & Drivetrain 07-30-2022, 06:30 AM
Replies: 13
Views: 1,097
Posted By fryzia23
And once you remove the bolt it looks like you...

And once you remove the bolt it looks like you still could use this kind of puller. From my experience 370z pulley comes off pretty easy.
Forum: Engine & Drivetrain 07-30-2022, 06:27 AM
Replies: 13
Views: 1,097
Posted By fryzia23
Have you tried power tools to remove it? My 1/2...

Have you tried power tools to remove it? My 1/2 Milwaukee impact gun didn’t even flinch when I took the bolt out my 2011 few months ago.
Showing results 1 to 25 of 447
Page 1 of 18 1 2311 Last »

 
Forum Jump

All times are GMT -5. The time now is 11:06 PM.

Contact Us - Home Page - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2