Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > Search Forums


Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: tjlazer
Forum: Engine & Drivetrain 06-04-2021, 04:50 PM
Replies: 1,022
Views: 137,482
Posted By tjlazer
Not sure if I’m on to something or not, but I was...

Not sure if I’m on to something or not, but I was having issues with a P0300 code for a long time and finally got that resolved by cleaning my MAF’s. Haven’t had any gas pedal issues since.
Forum: Parts for sale (Private Classifieds) 03-08-2021, 09:42 PM
Replies: 17
Views: 1,605
Posted By tjlazer
Seems they are all charging cores now which has...

Seems they are all charging cores now which has doubled the prices.
Forum: Engine & Drivetrain 02-26-2021, 12:13 PM
Replies: 15
Views: 4,806
Posted By tjlazer
I'm getting them all the time when it's cold out....

I'm getting them all the time when it's cold out. Car drives fine and the code clears itself after a while of driving.
Forum: Wheels & Tires 02-24-2021, 10:48 PM
Replies: 46
Views: 14,419
Posted By tjlazer
Did you pick these up? How is the fitment?

Did you pick these up? How is the fitment?
Forum: Parts for sale (Private Classifieds) 02-24-2021, 02:48 PM
Replies: 9
Views: 1,391
Posted By tjlazer
Still for sale?

Still for sale?
Forum: Wheels & Tires 03-04-2019, 04:20 PM
Replies: 18
Views: 8,064
Posted By tjlazer
Rear offset seems way off. Should be 40-45mm. ...

Rear offset seems way off. Should be 40-45mm. Should be easy to fix with a 20mm spacer though.
Forum: DIY Section (Do-It-Yourself) 12-28-2018, 01:09 PM
Replies: 65
Views: 84,857
Posted By tjlazer
Why didn’t you pull the fuse?

Why didn’t you pull the fuse?
Forum: DIY Section (Do-It-Yourself) 12-20-2018, 03:21 PM
Replies: 137
Views: 54,698
Posted By tjlazer
HID Bulb Change

It seems Osram is not following the Kevin chart with them though. There was a test done by retrofitsource.

https://youtu.be/rKEOIUrW39M
Forum: DIY Section (Do-It-Yourself) 12-18-2018, 12:29 PM
Replies: 137
Views: 54,698
Posted By tjlazer
HID Bulb Change

Something bizarre has happened the last decade. You cannot find high end 6000K HID’s. They don’t exist. You might find cheap china brands. Phillips, Osram, Morimoto all fall short of 6000k.
Forum: DIY Section (Do-It-Yourself) 12-08-2018, 01:18 PM
Replies: 137
Views: 54,698
Posted By tjlazer
I looked into it and the only way was to replace...

I looked into it and the only way was to replace the whole headlight! It's been fine so far with one clip. Bad design by Nissan. Not happy at all. Wonder if the new ones fixed this?
Forum: DIY Section (Do-It-Yourself) 12-08-2018, 01:17 PM
Replies: 137
Views: 54,698
Posted By tjlazer
Is just me or are 6000k bulbs today not as "blue"...

Is just me or are 6000k bulbs today not as "blue" as they were 6-8 years ago? They all seem to be pure white today! WTF.

https://www.youtube.com/watch?v=6FUxi5dqHAE
Forum: Engine & Drivetrain 11-07-2017, 05:36 PM
Replies: 33
Views: 23,872
Posted By tjlazer
How often does this code pop up on your Z? A lot...

How often does this code pop up on your Z? A lot of us have this randomly but not very often
Forum: Engine & Drivetrain 07-06-2017, 02:02 PM
Replies: 1,022
Views: 137,482
Posted By tjlazer
Is there anyway that an UPREV tune can address...

Is there anyway that an UPREV tune can address this throttle response when IAT temps are higher?
Forum: Exterior & Interior 04-20-2017, 04:08 PM
Replies: 18
Views: 3,380
Posted By tjlazer
I think he is just using the magnets to stick to...

I think he is just using the magnets to stick to the bottom base of the hatch, so the rubber springs hit them when the hatch closes.
Forum: Exterior & Interior 04-13-2017, 10:14 PM
Replies: 18
Views: 3,380
Posted By tjlazer
So these longer 350Z springs help or not?

So these longer 350Z springs help or not?
Forum: Exterior & Interior 01-31-2017, 03:57 PM
Replies: 12
Views: 2,726
Posted By tjlazer
Headlight HID swap broken tabs

I have found out that acetone works really good at fusing plastics so the next time I have my front bumper or wheels off I will try it. Not sure it will work but since the other side is intact it...
Forum: Engine & Drivetrain 01-24-2017, 04:57 PM
Replies: 87
Views: 22,228
Posted By tjlazer
HELP! Severe acceleration lag

I think it's IAT as I had been monitoring my air intake temps. It would spike when sitting at a red light, heat soak has to be it. I seem to have issues when I get to 190-200. Very bad lag on low...
Forum: Exterior & Interior 12-13-2016, 05:30 PM
Replies: 314
Views: 151,146
Posted By tjlazer
http://uploads.tapatalk-cdn.com/20161213/9ce908585...

http://uploads.tapatalk-cdn.com/20161213/9ce90858506028e0a4842a3fd1daf293.jpg
Forum: Nismo 370Z 08-01-2016, 05:53 PM
Replies: 15
Views: 9,879
Posted By tjlazer
I have them and they are ok. I got 6 whp...

I have them and they are ok. I got 6 whp increase with them. Dynod before and after.
Forum: Exterior & Interior 05-24-2016, 12:18 AM
Replies: 314
Views: 151,146
Posted By tjlazer
http://uploads.tapatalk-cdn.com/20160524/ab632c765...

http://uploads.tapatalk-cdn.com/20160524/ab632c7651e16bfa34d190a3870ae3d5.jpg
Forum: Engine & Drivetrain 04-30-2016, 11:20 AM
Replies: 127
Views: 33,453
Posted By tjlazer
Where's the MAP sensor at?

Where's the MAP sensor at?
Forum: Nissan 370Z General Discussions 04-30-2016, 12:01 AM
Replies: 122
Views: 13,111
Posted By tjlazer
Anyone know what happened? Seizure?

Anyone know what happened? Seizure?
Forum: DIY Section (Do-It-Yourself) 04-07-2016, 12:26 PM
Replies: 307
Views: 132,732
Posted By tjlazer
I had the same issue so I had to make sure they...

I had the same issue so I had to make sure they both pointed in the same direction.
Forum: DIY Section (Do-It-Yourself) 04-02-2016, 11:49 PM
Replies: 307
Views: 132,732
Posted By tjlazer
DIY: Oil Cooler (scratch built install, lottsa pics).....>.

As I was tightening the fittings I noticed one did not turn as much as the other so I had to stop. The other fitting seemed to be able to turn more on the threads. Did you have a hard time...
Forum: DIY Section (Do-It-Yourself) 03-28-2016, 12:23 AM
Replies: 307
Views: 132,732
Posted By tjlazer
I had issues also and it was a pain in the ***...

I had issues also and it was a pain in the *** trying to rotate the fitting. You might have to use a vice to try to rotate the whole cooler to move, and you might have to order a new fitting if it's...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 01:07 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2