Nissan 370Z Forum  

rock chips anyone?

Small chips can be "repaired" as follows: NOTE: Best to do when ambient temperature is 70 degrees F or greater. Surface should be slightly warm. 1. Buy a set of

Go Back   Nissan 370Z Forum > Nissan 370Z General Area > Nissan 370Z General Discussions


 
 
LinkBack Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-12-2009, 07:43 PM   #10 (permalink)
Track Member
 
Join Date: May 2009
Location: Ohio
Posts: 699
Drives: 370Z-AT7 Tour+Sport
Rep Power: 375
ZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond reputeZKindaGuy has a reputation beyond repute
Default

Small chips can be "repaired" as follows:

NOTE: Best to do when ambient temperature is 70 degrees F or greater. Surface should be slightly warm.

1. Buy a set of crayola crayons and pick the best matched single crayon to the car's color paint. Also buy a Clear-coat pen.

2. Buy some paint preparation fluid (autozone or advanced aut parts). Put some on a micro-fibre towel and gently wipe the chip and surrounding area off with the fluid. This removes wax and residue around an in the chip. Dry the area with a soft cloth.

3. Take the crayon tip and rub it across the chip until it is filled in. Wipe the excess crayon around the chip off using the paint prepartion fluid again.

4. Then take the clear-coat pen and with its fine and flat tip, apply a thin layer of clear-coat across the chip surface (with the crayon filler in the chip) in the longitudinal direction of the body part having the chip.

5. Let the clear-coat dry for about a 1/2 hour and apply another thin layer of clear coat. Let it dry for a 1/2 hour.

7. Put a light coat of liquid carnuba wax over it, let it haze and lightly hand-buff with a micro-fibre towel using the weight of the towel as pressure in the longitudinal direction of the body part.

The chip will be now blended into the surface of the surrounding area. The crayon will be resistent to direct sunlight and heat as it is now sealed with the clear coat. I just did this to my Pearl White 370Z hood that picked up two chips a 1/4 inch apart from each other. Can't see them now unless you get right down on top of them from about 2 inches away. The car sat in direct sunlight an entire car show this past weekend from 11:00 AM until 9:00 PM that evening. Absolutely no problem and still undetectable with no change.

This technique can also be used to fill in "dug-in" scratches as well.
ZKindaGuy is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
New Owner in Little Rock jikhead New 370Z Owner 15 04-07-2010 06:48 PM
Paint chips, part 2 kannibul Exterior & Interior 1 06-21-2009 08:02 PM
Paint chips ! B1nks Exterior & Interior 38 06-15-2009 08:03 AM
Here to Rock and Roll R1jamn Introduction 4 06-08-2009 09:55 AM
Hello from Little Rock! TheNewGuy New Forum Member 3 01-19-2009 01:49 PM


All times are GMT -5. The time now is 10:42 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2