Nissan 370Z Forum - Crush Washer?

Page 3 of 3

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Nissan 370Z General Discussions (http://www.the370z.com/nissan-370z-general-discussions/)

- - Crush Washer? (http://www.the370z.com/nissan-370z-general-discussions/6053-crush-washer.html)

SINISTER

03-23-2017 07:23 PM

Quote:

Originally Posted by vtec to vvel (Post 3236458)

For those that DIY oil changes, whenever you replace the copper o-ring on the drain plug, do you have a hard time getting it to go all the way down? Most of the time, it will go down to the second to last thread, but not completely down to the bottom of the bolt? :ugh2:

If you twist it on you can get it right to the bottom..but it yea second to last thread is pretty much right there. :tup:

ZoomZ

04-24-2017 12:06 PM

1 Attachment(s)

There is the right way and then there's the service manual way. ;) Note Image at top left. *1 and note C. Where 'C' is stated as oil pan side.

Attachment 121466

ZoomZ

04-24-2017 12:11 PM

So what's the torque on the Titek Magnetic plug? and Can I use the Nissan Copper washer with it?

Z1 says 17 Ft.lb for theirs, so I think that's probably be good for Titek. (since both are aluminum) I'm thinking even 19 Ft.lb would be ok.

All times are GMT -5. The time now is 03:33 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page