Oil change, Jack stands or ramps with diffuser?

VCuomo · 06-27-2009, 03:33 PM

Quote:

Originally Posted by NeedforZ

Same here. I use Rhino ramps and did my first oil change this morning at 1775 miles. I used a couple short 2x12s in front of the Rhinos to give the car enough lift so the chin deflector wouldn't hang. I did have to bevel the 2x12s with a jigsaw else the front tires would just push them across the floor. Worked perfectly. Gonna run Castrol GTX for a couple thousand miles before I go synthetic. Also, I would not have wanted lower ramps. I had just enough clearance to work without being too cramped.

You're using Rhino ramps and jackstands (picture shows a Craftsman jackstand)?

NeedforZ · 06-27-2009, 03:41 PM

The jackstands were just in case the plastic ramps collapsed. I slid them under there notice it's not actually supporting the car. Yeah I know the Rhinos are probably stronger than metal ramps. Call me paranoid but this is the first time I've used the plastic ones. Besides my 370z is a heavy girl at 3300lbs and I don't want her on top of me like that.

370Z Purist · 06-27-2009, 04:43 PM

Quote:

Originally Posted by NeedforZ

The jackstands were just in case the plastic ramps collapsed. I slid them under there notice it's not actually supporting the car. Yeah I know the Rhinos are probably stronger than metal ramps. Call me paranoid but this is the first time I've used the plastic ones. Besides my 370z is a heavy girl at 3300lbs and I don't want her on top of me like that.

.

I think jackstands would be more than enough. At least, if you get good ones, not the crappy ones. Then again, I've only seen them go as low as 2 tons.

ARFCOM · 08-06-2010, 11:29 AM

Which set of Rhino Ramps are you guys having success with on the 370Z?

Looking at the Rhino Ramp website there are three different sets of ramps. Two versions of the 12,000 lb ramps and then a single version of the 8,000 lb ramps.

06-27-2009, 03:41 PM	#2 (permalink)
NeedforZ Base Member Join Date: Mar 2009 Location: DFW Texas Posts: 163 Drives: 370z Touring 7AT Rep Power: 18	The jackstands were just in case the plastic ramps collapsed. I slid them under there notice it's not actually supporting the car. Yeah I know the Rhinos are probably stronger than metal ramps. Call me paranoid but this is the first time I've used the plastic ones. Besides my 370z is a heavy girl at 3300lbs and I don't want her on top of me like that. Last edited by NeedforZ; 06-27-2009 at 03:43 PM. Reason: clarity

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Oil Change	armensti	Engine & Drivetrain	155	04-18-2012 01:39 PM
Jack Stands	Minicobra1	DIY Section (Do-It-Yourself)	19	03-07-2010 04:54 PM
1st Oil Change	tooohip	Mid-Atlantic Region	4	06-25-2009 07:50 PM
(Noob question) SRM stands for?	leepeen	Nissan 370Z General Discussions	1	05-25-2009 08:33 PM
First Oil Change	cotizi	Engine & Drivetrain	3	03-27-2009 11:34 AM

08-06-2010, 11:29 AM	#4 (permalink)
ARFCOM Base Member Join Date: Jul 2010 Location: Missouri Posts: 75 Drives: 2010 370Z Red 6 spd Rep Power: 16	Which set of Rhino Ramps are you guys having success with on the 370Z? Looking at the Rhino Ramp website there are three different sets of ramps. Two versions of the 12,000 lb ramps and then a single version of the 8,000 lb ramps.