swapped back to weds. this time running 285/35/19 on the rear vs 275/35/19.

http://www.the370z.com/avatars/kench...ine=1371783863

Your small picture is small.

here

http://www.the370z.com/members/kench...7909-thumb.jpg

Plastidipped my door handles gunmetal with glossifier. Came out great! However, I messed up while applying glossifier to my rear bumper so I had to remove the whole plastidip which turned out to be harder than advertised :(

now you're just wasting bandwidth

Hood pins sloppily installed.

At least the sloppy part is inside the engine bay where you can't normally see it. Sigh.


http://www.the370z.com/attachment.ph...1&d=1371790821

Finally got time to put on my CBE from Magnaflow, as well had the clutch swaped out for a ACT unit, and a flywheel from Stillen. Tomorrow, the new stereo install starts.

I see your smaller thumbnail and raise you a micro thumbnail...

http://i899.photobucket.com/albums/a...pse5fc3599.jpg

:icon17:

Ok you win. :icon17:

Late for work today because after dropping off my kid in the Forester, decided to go back home and switch to the Z since its so nice out!

Definitely worth it :tup:

Ordering the hood props today from Z1, looking to do some smaller "fine touch" mods. I got Nismo oil cap and radiator cap, red dress up bolts...not sure what else I could do...

You could replace hoses if you haven't already. Also, if painting the strut tower brace is too much for you, you might consider something small like a Z logo or anything else that fits your taste.

Well my strut bar says "40th anniversary" So I'll leave that but good idea on the hoses :tiphat:

I know the rad ones and the smaller ones near the engine cover are pretty easy, I hear the rest are a pita to get to

There's also the Engine Bay Wire Tuck DIY to clean things up a bit :tup:

http://www.the370z.com/diy-section-d...wire-tuck.html

Changing my oil hopefully Thanks to AKs diy. Headed to autozone. Unfortunately im driving unbadged since it took longer than i thought to get the old adhesive off. Looks like crap in the back without the burger