Had to wrap up early yesterday as I was attending to the plumber.
Mr.gale- good to hear you are keeping buzy. Don't work too hard! :tup:

Pulling out my Z in 15. :p

Are those an R compound tyre?

Where is Mr. Shado going? I hope it is not prison or deportation.

Coffee/Cars
 

Not many Zs but other variety of Porsches and a Ferrari, Lotus, etc. Coffee good. Blueberry scone for breakfast. Got to hobnob with the elite--parked next to a 40th Anniversary. Some folks wandering around, asking questions, especially concerning the 7AT and paddle shifters. My comment was that it was rather easy and sporty to drive because the transmission, in manual mode, downshifted rather aggressively on its own during braking. Easy enough to drop one more gear if needed or simply to begin shifting back up through the gears.

Nissan 370Z Forum

Nissan 370Z Forum

Nissan 370Z Forum

http://www.the370z.com/attachment.ph...1&d=1342886344

http://www.the370z.com/attachment.ph...1&d=1342886344

http://www.the370z.com/attachment.ph...1&d=1342887114

http://www.the370z.com/attachment.ph...1&d=1342887114

:shakes head:

Hope you change your mind in about a day.

Motored my Z and QD'd afterwards. Was a great drive. :p will check out later how the Olympus mic did. :p

I put about 150 miles on mine, still 1000 to go for break-in, but I know what to expect so it's not quite like waiting for Christmas morning or anything. :)

Im about to go outside and replace my blown gasket, again. We will see if this one lasts longer than 2 months.

Al, dont tell me your panties are in a bunch from the little tiff you got into w G2Z in the 5.0 thread:icon14:

Morning all, I will be driving the Z in a few hours. :driving:

Good luck, What a pain in the azz that is.

G2Z is still here? tell him "bye!" :hello: :tup:

Thanks. Any idea of the torque specs on those bolts??

He stops by the mustang thread occasionally.....

The cat to Y-pipe nuts are 39 ft-lbs -- according to the manual.

Here is the section:

:icon18: