3M CF/DiNoc-wrapped illuminated kick plates

kenchan · 06-30-2011, 11:16 AM

Quote:

Originally Posted by FromG2Z

Ken... thanks for the pic. Did you have to remove the kick plate to install the 3M CF vinyl? I hope it wasn't a pain

Also, you wrapped the section opposite of what I was thinking. I wanted to have the black curved plastic section to be wrapped while leaving the silver section as is. What do you guys think of that?!?!?!

no, im a pretty lazy guy so i just cut to shape and placed it on there.

i think the reverse is a nice contrast but might have a hard time adhering to the textured surface unless you take the piece off and wrap it around. id' also use adhesion promotor as well.

Quote:

Originally Posted by augustabites

Nice pic Ken!!

For someone who can snap a rubber strap wrench, you have a delicate touch (complement).

Did you use adhesion promoter for this?
(i'm noticing that di-noc isn't as forgiving as i was made to believe).

Thanks.

---Augustabites

hahaha!~

im a musician so i have very fine motor skills too.

on the bits i DiNoc'ed i did not use adhesion promotor. DiNoc sticks very well to smooth surfaces but has a harder time on textured surfaces. if im doing the black part of the kick plates i would use adhesion promotor and wrap it to the back of the piece.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Illuminated Kick Plates	ejrives	DIY Section (Do-It-Yourself)	133	07-12-2019 01:12 AM
Illuminated kick plates always on?	KptKIDLAT	Exterior & Interior	15	08-30-2012 10:08 PM
WTB: Illuminated Kick Plates	Boost_lee	Wanted	0	01-30-2011 03:28 PM
Illuminated Kick Plates	KptKIDLAT	DIY Section (Do-It-Yourself)	3	08-29-2010 08:53 AM
Illuminated Kick Plates	twotonezed	Parts for sale (Private Classifieds)	7	06-22-2010 12:53 AM