engine break-in contradiction

ZKdoggZ · 06-19-2012, 01:48 AM

Manufactures are making engines with much higher tolerances today. Where cylinder clearances used to be in the thousands of an inch, now its in the ten thousands. Bores are rounder and straighter. There is know reason to baby a newer engine, it will actually hurt. You need cylinder pressure to drive the rings out onto the bore, which actually shaves the bore into a perfect fit. By babying it the rings will only rub and burnish the surface leaving a less then Ideal finish. So ... keep the revs below 4000 the first 300 miles, then drive it ... accelerate with meaning for the next 2500 miles and your all set. This is how all High Performance engines are broken in, and all engines today can be considered a high performance engine since they pull more power out then there predecessors ever did.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Recommendations on how the break-in a new engine	1Sweet Z	Nissan 370Z General Discussions	40	05-04-2011 09:37 AM
Just finished my break-in period, does this engine not like to rev?	rsximus	Nissan 370Z General Discussions	32	03-20-2010 02:15 PM
Controversial engine break-in method	LaSeeno	Nissan 370Z General Discussions	13	03-16-2010 08:41 PM
How do you break-in your new engine?	ZKindaGuy	Nissan 370Z General Discussions	24	08-23-2009 05:20 PM
engine break in question (350 mile trip)	Santent	Engine & Drivetrain	6	06-26-2009 09:43 PM

06-19-2012, 01:48 AM	#27 (permalink)
ZKdoggZ Base Member Join Date: May 2012 Location: Dallas Posts: 98 Drives: 2012 370Z 7AT PW Rep Power: 14	Manufactures are making engines with much higher tolerances today. Where cylinder clearances used to be in the thousands of an inch, now its in the ten thousands. Bores are rounder and straighter. There is know reason to baby a newer engine, it will actually hurt. You need cylinder pressure to drive the rings out onto the bore, which actually shaves the bore into a perfect fit. By babying it the rings will only rub and burnish the surface leaving a less then Ideal finish. So ... keep the revs below 4000 the first 300 miles, then drive it ... accelerate with meaning for the next 2500 miles and your all set. This is how all High Performance engines are broken in, and all engines today can be considered a high performance engine since they pull more power out then there predecessors ever did.