Help with kickplate install

Chuckster · 01-08-2010, 11:34 PM

I just installed my illuminated kickplates, following the directions provided and the instructions in the DIY section. Now that I'm completely done and put everything back together, I discovered that windows aren't operating normally. When I open a door the window goes down about a quarter inch, like it supposed to, but then it doesn't go back up when I close the door. If I open the door again, it goes down about another half inch and stays there when I close the door. I can put the window up using the button. Both sides do the same thing.

There's really not anything I could have done differently, because you basically just disconnect a connector, put the T adapter in the middle and connect it back up.

Has anyone had this problem? Does anyone have any suggestions?

01-08-2010, 11:34 PM	#1 (permalink)
Chuckster Base Member Join Date: Jul 2009 Location: Albuquerque, NM Posts: 18 Drives: PG/Pers/Sp/Tr/Nv/6MT Rep Power: 15	Help with kickplate install I just installed my illuminated kickplates, following the directions provided and the instructions in the DIY section. Now that I'm completely done and put everything back together, I discovered that windows aren't operating normally. When I open a door the window goes down about a quarter inch, like it supposed to, but then it doesn't go back up when I close the door. If I open the door again, it goes down about another half inch and stays there when I close the door. I can put the window up using the button. Both sides do the same thing. There's really not anything I could have done differently, because you basically just disconnect a connector, put the T adapter in the middle and connect it back up. Has anyone had this problem? Does anyone have any suggestions? __________________ I have kleptomania, but when it gets bad, I take something for it.