Fly1 Duckbill Wing Install - HELP!!!!

slammedsammy

Hey guys,

I'm going to give you the short version of this story...I'm looking for advice from you guys because I honestly don't know what to do.

Today I went to a custom body shop to have my Fly1 carbon fiber duckbill wing installed. I was quoted for an hour for the install so I said I would wait around for it to be done....well it took 2.5 hours and they charged me $189 to install the stupid thing when they said it would only take an hour and would cost about $70...

After it was all said and done, I go out to inspect the wing and they mounted it off-center....now idk about you guys but this is completely unacceptable....they mounted the wing using 4 bolts in the 4 holes that fly1 puts on the bottom of these wings. I have a Z that does not have factory holes already drilled, so somehow when they tried to line up the wing, they did so off center about a half inch or quarter inch...

To rectify the situation...they offered me $25 off the install ($25 f&*#ing dollars?!) or to reinstall it and plug the holes...So then I'll have 8 god damn holes in my trunk if I ever decide to take the duckbill off...

What would you guys do if you were in my situation?

- I attached the picture twice in case one was too big or too small to see.

Attached Images

IMG_8234.jpg (288.2 KB, 97 views)

__________________
"It's nice to be important...but it's more important to be nice."