|
So are you positive it's the cooler itself? Who did the install? I know when I received my kit from GTM one of the 45 degree AN fitting was tight
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
08-12-2011, 08:56 AM
|
#10 (permalink) |
|
A True Z Fanatic
 
Join Date: Feb 2010
Location: Covington, GA
Age: 46
Posts: 14,844
Drives: Waiting on next Z
Rep Power: 222   |
So are you positive it's the cooler itself? Who did the install? I know when I received my kit from GTM one of the 45 degree AN fitting was tight but not tight enough for it had a very small leak (very mild). So I tighten it down about another 3/4 of a turn and been good since. So basically check the fittings before install them also.
__________________
 |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler | Dustin@Z1 | Engine & Drivetrain | 158 | 03-10-2014 02:27 PM |
| Oil cooler orientation (Z1 cooler) | BrandonT | Engine & Drivetrain | 10 | 05-23-2011 08:26 AM |
| STILLEN oil cooler kit + STILLEN power steering cooler = fit? | ZBW39 | STILLEN | 2 | 07-02-2010 01:08 PM |
| Oil Cooler.....Trans Cooler... | kannibul | Engine & Drivetrain | 6 | 12-31-2009 06:32 PM |
Threaded Mode
