redondoaveb

Hey man, love your build! You've inspired me to build mine! I'm going to go for a Tomei with cat deletes and maybe some red JNC wheels like yours!

Hey brotha,

Currently installing the topgunz SC kit, and going the route of installing a external wastegate to help with in cabin boost control...Saw on one of the threads you went the same route...you happen to have a picture or explanation of this? just dont want to cut into the wrong piping if their is a better placement as its pretty tight in our bay with this kit

What size is your walbro fuel pump?

Hello, you said you followed me on Insta, what is your instagram?

Which Southbend Clutch are you running, and would you recommend it for a daily driver? I am ordering parts for my ACE Supercharger set up, and I am having a hard time with picking a clutch. I will be running e-85 and anticipate getting 420-460 rear wheel torque. I have a 10 mile daily commute in Chicago traffic.

Hey man, I finally received the switch. I have a question about your wiring. It's been a while since my electronics class so, bear with me. How did you wire up the switch to enable the halo light as well?

I'm guessing Common is connected to one end of the spliced Yaw Sensor Wire, and the other end is connected to Normally Closed. How did you wire up the halo light on the switch? Thanks for any help.

https://i.imgur.com/IR8oktl.jpeg

If you wanna bring religious texts into the mix, people have ridden flaming chariots into the sky

Who the **** would want to visit us anyways? ******* species cant even get along with ourselves.

Well this is going on deepfreeze lol won't get the rods until September. 18 week lead time.

Also it will work with any standard vhr piston(stock or aftermarket) just lower the rated compression by a point. So stock vhr pistons would be about 9.9:1 Edit as a side note stock vhr pistons...

Can't give away all the secrets lol it's a forged crank and not reworked, just adapted. And it may be no Bryant billet tool steel deal but it works and it's not $4000. It has all the heat treating...

:iagree: Red loctite and stake the bolts

:iagree: Dimple it.

For the hardware that Nissan (and other kits) use, use a punch to dot the rim of the screw head once installed. The indentation will help prevent the problem of the screw backing out on its own.

The older paper gaskets are garbage, yes, but the newer metal ones did not entirely fix the issue. That's because the hardware that Nissan (and other kits) use is also part of the problem. Get the...

There have been a few posts on FB with even a few of the newer engines having the same gasket issues. If you're going to replace them, go with the EPS kit since it comes with better hardware; I...

Too funny. Q-q_J5IyoKE

They look like 5 yrs old created them. Very easy to do with the man power. It's like asking how people created stonehedge without modern day equipment to move thousand ton boulders. Not everything...

Modern day ones might be military, but some of the older reports of UFOs (before the age of flight) are highly doubtful that they are military. There are the petroglyphs in South America that can...

Fix campaign financing and a lot of our political problems will go away on their own. For many years I have been against term limits - let the people elect who they want, even if a bozo. I'm...