redondoaveb

Hey man, love your build! You've inspired me to build mine! I'm going to go for a Tomei with cat deletes and maybe some red JNC wheels like yours!

Hey brotha,

Currently installing the topgunz SC kit, and going the route of installing a external wastegate to help with in cabin boost control...Saw on one of the threads you went the same route...you happen to have a picture or explanation of this? just dont want to cut into the wrong piping if their is a better placement as its pretty tight in our bay with this kit

What size is your walbro fuel pump?

Hello, you said you followed me on Insta, what is your instagram?

Which Southbend Clutch are you running, and would you recommend it for a daily driver? I am ordering parts for my ACE Supercharger set up, and I am having a hard time with picking a clutch. I will be running e-85 and anticipate getting 420-460 rear wheel torque. I have a 10 mile daily commute in Chicago traffic.

Hey man, I finally received the switch. I have a question about your wiring. It's been a while since my electronics class so, bear with me. How did you wire up the switch to enable the halo light as well?

I'm guessing Common is connected to one end of the spliced Yaw Sensor Wire, and the other end is connected to Normally Closed. How did you wire up the halo light on the switch? Thanks for any help.

Still no dyno sheets supporting that claim

:iagree: on E85 that is

Yall running from cops a lot?

New tires are in. It is too cold to mount them up. It needs to be 68deg to be able to mount them. Next week it will be high 60's and low 70's. Shooting for Monday or Wednesday worst case.

It is getting real close. Enough said.

Beautiful seats, I've never heard a bad thing said in regards to Cobra.

Very Nice!!:tup:

Hit up Galeforce, I believe he was/is running those seats, well the Takata branded version at least. May have to search him out on instagram or facebook.

You won't find a single bad review at Z1 or Stillen or any small vendor, their products are always excellent every time. Except when there not and those don't get approved.

All you can do is be honest... and sounds like you were...

This is the review that I'm posting again. :icon14: If you have exhaust like FI that are close to the diff. This brace won't fit unless you trim about 1 3/8" on the corner of the brace. The other...

Just seen this on the Z1 website. "Thank you for your review. It has been submitted to the store owner for approval and should appear shortly."

When in doubt pull out! LMAO Sent from my SM-G965U using Tapatalk

Mine just showed up last night. I knew I should have waited. Dang it. No worries, I will make Chicken soup out of Chicken poop.

The only time this will be awesome is if you get wheel hop. That is when the rear diff stud may break. If you get wheel hop, let off to protect your parts.