NorthStyle

Hello,

Wanted to let you know if you ever decide your considering letting go of your ganadors please keep me in mind. I'm def interested and may be for a while till I source a set.

Hey

Hi,
ich lese gerade du fährst das Juke Nismo Lenkrad in deinem 370z.
Ist das echt komplett gleich bis auf den Airbag?

Viele Grüße aus Köln

You didn't sit in the car before you purchased it?

Yes... although they remade it into pretty much an entirely different car. Halcón SuperSport (http://halcon-supersport.com/)

From Meet the Street v4 (Kaiserslautern, Germany)... yeah, I need to paint the mirrors :p ...

Got my drivers side in. Will do the passenger once I figure out a good way to take care of the weight sensor. ...

Got my drivers side in. Will do the passenger once I figure out a good way to take care of the weight sensor. ...

Got my drivers side in. Will do the passenger once I figure out a good way to take care of the weight sensor. ...

One of the two [black] sleeves that run from the outside edge of the door towards the front of the car (closest to the lateral seat cushion in the picture) controls the interior door handle. Pull on...

I think how good it looks depends on the exhaust system you have. I think it works well on your car because your exhaust has multiple pipes, so it shows it off. For something like the Nismo, Armytrix...

I have the Cipher Racing version of them. Pretty much the same as far as I can tell and are TÜV approved (German version of DoT). I ended up purchasing these since the Corbeau version wasn't...

No, so long as your care is properly setup you shouldn't notice any additional wear-and-tear. However, it would be in your best interest to let the car warm up prior to driving it. I will follow...

I have them. Unfortunately, my car's in the shop getting some suspension parts installed but I followed the Z1 installation guide for their hood struts since it's exactly the same. ...

Thanks jchammond and /Angelo350Z/, I was planning on running around -2 - -2.75 so hopefully it'll fit just fine. I prefer negative in the front for the same reasons.

Just an update and to close out this thread: I finished wiring the rest of the system up, double-checked functionality, then buttoned everything up. I wasn't able to figure out the programming of...

Shouldn't do anything to the seats as I've had battery plugged/unplugged multiple times over the past two weeks. For the windows, I had to reset them each time but that only takes about a minute...

After looking through DeliriousClam's diagram(s) I saw that there was no pin 18 for the base/Nismo Z so went ahead and wrapped up the first harness. Soldered/shrink wrapped ...