NOBLE|370Z

Base Member

Last Activity: 06-22-2025 07:06 PM

About Me

About NOBLE|370Z

Location

Calgary AB

Occupation

Oil and Gas Engineer

Drives

09 Nissan 370Z

Statistics

Total Posts

General Information

Last Activity: 06-22-2025 07:06 PM
Join Date: 09-17-2011
Referrals: 0

Friends

Showing Friends 1 to 3 of 3

cooltoy

Elite Member
F.I. Inc.

The370Z.com Sponsor
SAM@GTM

NOT AN ACTIVE SPONSOR. DO NOT BUY

Likes Given

22 Likes

NOBLE|370Z liked post by fillerbunnie On thread : DIY: Clutch Master Cylinder (CMC) replacement and rebuild

Hey everyone, After looking at the cost of a rebuild kit vs replacement kit for the CMC, I thought I would do a quick DIY for anyone thinking about replacing it. The rebuild kit is about the $20...
Liked On: 07-30-2017, 02:29 PM
Posted On: 02-11-2017, 11:49 PM
NOBLE|370Z liked post by 12nismo On thread : Who's running a lightweight crank pulley?

I could be wrong, but other than a few cases of the actual pulley itself failing (usually due to bad installs) I haven't seen any engine issues (spun bearings, broken crank, etc) that was linked to a...
Liked On: 09-19-2015, 08:30 AM
Posted On: 08-31-2015, 08:12 PM
NOBLE|370Z liked post by Mr&Mrs On thread : GTM Stage 2 TT Dyno Results - Finally

Looks like the typical safe tune from GTM. I do not know their turn around right now but you can probably email it and have them lean it out some as you suggested already. I do not drive much but I...
Liked On: 07-05-2014, 08:32 AM
Posted On: 07-05-2014, 07:25 AM
NOBLE|370Z liked post by Staples On thread : GTM Stage 2 TT Dyno Results - Finally

The canned tune is fine, just super conservative. You're right about too much fuel and not much timing causing the backfiring issues, but this is a safety net Sam has to do since each car is...
Liked On: 07-05-2014, 12:14 AM
Posted On: 07-04-2014, 11:37 PM
NOBLE|370Z liked post by Legz On thread : GTM Stage 2 TT Dyno Results - Finally

Glad your Z is running smoothly, and putting down good power. I'm running canned tune 8.5 PSI 94oct from GTM as well for 2 years, mine has not seen a dyno yet.
Liked On: 07-04-2014, 10:07 PM
Posted On: 07-04-2014, 09:23 PM
NOBLE|370Z liked post by phunk On thread : The E85 Mystery

There is no doubt that just injectors and pump could make over 600rwhp with gasoline. Its just not recommended as it wouldnt be considered "safe". But if you know what you are doing and watch what...
Liked On: 06-30-2014, 12:16 AM
Posted On: 06-23-2014, 12:53 PM
NOBLE|370Z liked post by djtodd On thread : The E85 Mystery

There are quite a few of us running 600+ for some time now. But admittedly no one with 20k miles or so. Just give it time :) I'm convinced 600 with proper fuel, cooling, and tune is well within...
Liked On: 06-22-2014, 09:50 AM
Posted On: 06-21-2014, 02:42 PM
NOBLE|370Z liked post by Jordo! On thread : The E85 Mystery

If quenching hotspots are the only issue, then, yes, that follows. Also, if E85 has a lower stoichiometric ratio than regular petrol I believe that translates into more potential energy (i.e.,...
Liked On: 06-21-2014, 09:47 AM
Posted On: 06-19-2014, 03:45 PM
NOBLE|370Z liked post by TopgunZ On thread : The E85 Mystery

A huge percentage of engine failure, maybe high 90s even, is due to detonation. E85s resistance to this is incredible. You could have a car pushing 350whp and detonating like crazy and the engine...
Liked On: 06-21-2014, 09:43 AM
Posted On: 06-15-2014, 09:49 PM
NOBLE|370Z liked post by Chuck33079 On thread : My motor grenaded.

Could the motor have just let go? Sure, it could have happened that way. But considering how much difficulty VSR had getting the SC installed and running right in the first place and then the motor...
Liked On: 05-20-2014, 10:45 PM
Posted On: 05-20-2014, 10:34 PM
NOBLE|370Z liked post by modme On thread : Driveshaft issue? Speed related Vibration

It turned out to be the driveshaft. One of the drive shaft to differential nuts and bolts fell out. It's back to normal now after replacing it.
Liked On: 04-13-2014, 06:07 PM
Posted On: 04-13-2014, 04:43 PM
NOBLE|370Z liked post by Trips On thread : Major Vibration Issues - Help

Vibrations can come from anywhere like from an unbalanced flywheel/clutch, loose driveshaft, bad u-joints, rearend, loose or out of balance wheels. Have everything looked over carefully before it...
Liked On: 04-13-2014, 01:49 PM
Posted On: 04-13-2014, 12:54 PM
NOBLE|370Z liked post by Mr&Mrs On thread : GTM stage 2 TT with FI 3" CBE

I now own Dembflyr's car and the exhaust was non resonated.
Liked On: 02-17-2014, 09:43 AM
Posted On: 02-17-2014, 05:30 AM
NOBLE|370Z liked post by Boosted Performance On thread : GTM stage 2 TT with FI 3" CBE

Those work very well. I have a couple of customers with them: http://8903e7f0897f2982f439-51d6683c30d3fc51d493ee4745c5d29a.r14.cf2.rackcdn.com/uploaded/d/0e546393_disc-only640x480.jpg You...
Liked On: 02-17-2014, 09:42 AM
Posted On: 02-17-2014, 01:10 AM
NOBLE|370Z liked post by 1slow370 On thread : GTM stage 2 TT with FI 3" CBE

he could always try muffling the wategate pipes, a small glass pack or spark super trap works great, that is if you don't want to go recirc.
Liked On: 02-17-2014, 12:13 AM
Posted On: 02-16-2014, 06:41 PM

Page 1 of 2

NOBLE|370Z

Base Member

About Me

Statistics

Friends

Likes Given

Mini Statistics

Friends

Recent Visitors

	cooltoy Elite Member

	F.I. Inc. The370Z.com Sponsor

	SAM@GTM NOT AN ACTIVE SPONSOR. DO NOT BUY