NissanGuy23

Thanks for the link. I wonder if that will fit the rear emblem also... BTW antfd totalled his nizmo.

Wrapping is pretty costly isn't it?

Any mods on your Z yet? I've looked and found nothing. Lol

It was a deal on TravelZoo, but you can probably find it on Groupon too. It was a good experience, but honestly I think you'd have more fun taking your own car on the track. I had more fun driving the Z. It's like $50 to do a 20-25 min hyperdrive session in your own car (on a bigger track) vs $150 to do 2 laps in the Lambo/Ferrari thing which is like 2.5 mins. If you still want to do it just to drive a Gallardo or F430 then go for it.

Thanks!

you mean the very functional turn signal lights mounted on the fender? if you actually use a turn signal when going in and out of traffic they are great!!!

PM LMBmikeZ

Yes, they are dummy spots. I bought mine used and noticed a lot of rattle coming from my rear speakers. After some research, I learned normally the Nis doesn't come with those rear speakers, someone...

Freshly clean.. 85403 85404

https://scontent-b-atl.xx.fbcdn.net/hphotos-prn1/t1/1555335_454374254692260_2033243576_n.jpg

Maaaaybe because you grew up around them? I'm the same way but opposite of you lol jdm at heart but I do like the sound of a v8 rumble...

sounds to me like an install issue. I would have been wary once the shop guys told you they couldn't figure out where the wires went because of the last guys install. BS, straight up. A professional...

i finally had a chance to setup the rig that i made to get some shots. check em out https://farm8.staticflickr.com/7454/13074728775_5d8d25e922_c.jpg...

GJ nissanguy. no worries on the t-taps. i use it all the time with no ill effects. also really no issue going directly to factory wiring. it's just easier to revert back to stock if you use one...

Wut?

You can do it one of two ways, using a panel removal tool carefully push the wire between the dash and the glass and than between the dash and the a pillar, or remove the tweeter grill with a pry...

also these male spade connectors to plug into the taps :D Amazon.com: 3M Scotchlok Nylon Fully Insulated Male Spade Type Connectors 22-18 Gauge (Red) - 100 Pack: Car Electronics...

for the main harness i solder the wires and wrap them with e-tape or shrink tubing. as for the steering control modules, etc, i use these taps: Amazon.com: Install Bay 3M T-Tap Connector 16/14...

definitely do the steering controls. it's worth the trouble. if you want to do the metra axxess, i suggest asking Big (he's an installer/sponsor) about which firmware to use. people where having...

yah, the main harness looks right. i forget how i hooked up the antenna harness, but i used the remote turn-on (blue/white) wire from the HU to fire it up. your setup should work since you are...