Nissan 370Z Forum - Corsairprime's Album: Z1 Brake Cooling Kit

		Nissan 370Z Forum > All Albums > Corsairprime's Profile > Albums
Z1 Brake Cooling Kit - 2014 Nismo

Z1 Brake Cooling Kit - 2014 Nismo

A brief picture essay of the Z1 Brake Cooling Kit install. The Front bumper cover is the Fuji from Fly1. Grills are #5 Stainless steel and the intake ducts are Howe Racing RE305s.

The intake end of the cooling tube. Shown is the 2.5" Z1 cooling tube, the 2.5" aluminum connector and the 2.5" to 3" silicone adapter tube. This...

The completed install. Fuji front bumper stainless screens and intake ducting.

The connection to the Howe Racing Intake duct installed attached to the to the screen behind the Fuji Front bumper. View from below.

Remove the wheel to get at all the parts to be connected.

Measure and connect the cooling tube to the Z1 backing plate (installed previously).

Route the cooling tube as shown behind the suspension arm. I have not found a need to secure it to the arm as others have done. This tube is quite...

This is the one location I did secure the tube to the frame with a zip-tie. It passes thru the fender liner to connect to the Howe Racing RE305...

Shown here is the cut out piece of the wheel well liner to allow the cooling tube into the wheel well area.

This is the Howe Racing RE305 intake duct and a 3" to 2.5" silicone adapter. 2x are required for this install.

The Stainless #5 screen to keep rocks out of the brake cooling duct and tubing.

This image shows the Screen, and intake duct attached to the back of the Fuji front bumper.

You will need to cut an opening in your fender liner to allow the duct tubing to reach the front wheel area.

These are some of the parts and tools required to make this install happen. The tubing is the black cooling tubing (2.5" from Z1. You will note...

All times are GMT -5. The time now is 05:04 PM.