Originally Posted by eastwest2300 (Post 2197113)

Hey whats up man?

Originally Posted by italy3541 (Post 2197114)

nada. just reading u guys go back and forth...:bowrofl:

Originally Posted by italy3541 (Post 2197112)

so iv been reading everything thats going on i n here and its some good lol's... in all seriousness guys.. everyone is running almost the same mods. the hp difference will be minimal in the cars that are going to race.. what it will come down to is the driver.. iv been drag racing since i was 16 and i can tell you that the key to a good time are as follows.. 1. launch. the most important.. without a good one ur time will be bad. 2. shift points. this is also important because missing a shift will kill time, also knowing what rpm is the best to shift at.. it isnt always at redline for best result.. it takes many runs to determine where the best shift point is, in some of my past cars i saw best times shifting 200-300 before redline. im not saying thats the case in the z im saying that you have to learn the car to run the best time.. now if ur running a automatic then again you will have to learn when to use ur paddles to shift etc.. what im trying to say is going back and forth when the cars are almost the same is pointless.. it will come down to who is the better driver. people always say that drag racing is easy, compared to track raceing it is.. but there is still talent involved with it and learning your car is key to running a good time. you dont just dump the clutch n floor it. sorry for the rant but fighting back and forth about whos car is faster when they are almost the same is pointless.. the argument should be who is the better driver because that is what it would come down to..

Originally Posted by FPenvy (Post 2197125)

buttttt fighting and talkin smack is fun :stirthepot:

:hello:

Originally Posted by eastwest2300 (Post 2197111)

says the guy that had a hard time installing kick panels...:stirthepot:

Originally Posted by italy3541 (Post 2197126)

:hello::tup:

Originally Posted by FPenvy (Post 2197125)

buttttt fighting and talkin smack is fun :stirthepot:

:hello:

Originally Posted by dmhenderson (Post 2197129)

Not really. I wasn't sure where the pry points were but after I fiddled with them for 30 minutes, I was done in less than an hour.

Originally Posted by dmhenderson (Post 2197109)

Oh come on. Changing out a shift knob takes 30 minutes tops and that's if you're SUPER careful.

Originally Posted by b1adesofcha0s (Post 2197133)

This guy knows all about butt fighting :bowrofl:

Originally Posted by Masa (Post 2197131)

Well, this whole troll-fest started when Party A claimed to be able to beat Party B in a drag race without any prior runs or practices. Just one run. :rolleyes:

Now that its coming up one party is claiming to have no prior knowledge of event. Mind you, this has been going back for the last couple months now. :ugh2:

Originally Posted by eastwest2300 (Post 2197134)

didnt you create a thread about this install?:roflpuke2: hold on let me find it... trollolololl

Originally Posted by m4a1mustang (Post 2197144)

50,000 posts bitchez!!!

Originally Posted by chieuxuan (Post 2197146)

Fyck, I'll race both parties with my Turbo Vtak Accord :stirthepot:

Originally Posted by b1adesofcha0s (Post 2197145)

Well just to settle this little issue, I'm going to Capitol Raceway on March 9th. Frank and I are going to have a friendly race against each other that day at the drag strip. If Dee shows up then I will be happy to race against him too. I'm 99% sure this will be my last day at the drag strip with the Z. Drag racing is getting boring to me and I'm just going one last time after I get my tune. After that it's only HPDE's for me. :driving:

Originally Posted by b1adesofcha0s (Post 2197151)

In that case, I'll have to bring the Prius :stirthepot:

Originally Posted by dmhenderson (Post 2197141)

Yes, the thread said "hey does anyone remember how to remove kick plates" because I had resistance taking off the passenger side where the double sided tape had bonded to the running board.

Once I figured out what was causing the problem, it was cake.

Originally Posted by MyKindaGuise (Post 2197157)

Ill bring my 10 speed bike. Should be fair. Ill just have to peddle slower.

Originally Posted by m4a1mustang (Post 2197144)

50,000 posts bitchez!!!

Originally Posted by italy3541 (Post 2197163)

:bowrofl::roflpuke2:ill go get my turbo wheel chair from when i hurt my knee. ill destroy everyone!!!!!!!:roflpuke2::roflpuke2:

Originally Posted by MyKindaGuise (Post 2197172)

Only if you have spinners on it. Classy race wheel chair.

Originally Posted by dmhenderson (Post 2197166)

I think we have different definitions of the word "troll"

Originally Posted by italy3541 (Post 2197163)

:bowrofl::roflpuke2:ill go get my turbo wheel chair from when i hurt my knee. ill destroy everyone!!!!!!!:roflpuke2::roflpuke2:

Originally Posted by eastwest2300 (Post 2197178)

i guess so, well we can say.. "parting shots" you threw one, I threw one back..

Originally Posted by FPenvy (Post 2197192)

oh just pull the string nd go to the track :stirthepot:

:bowrofl:
:tup:

Originally Posted by eastwest2300 (Post 2197199)

Dude, the cars' not ready, it wont be good to go until Saturday afternoon.

Originally Posted by FPenvy (Post 2197200)

from what i understand and what i've seen you have been "getting it ready" since well before i joined this site lol

stop buying random parts and start installing them already :tiphat:

Originally Posted by eastwest2300 (Post 2197199)

Dude, the cars' not ready, it wont be good to go until Saturday afternoon.

Originally Posted by eastwest2300 (Post 2197202)

:roflpuke2: You must have missed the big columbia meet that I brought the Z up and showed everyone that all those "random" parts were in fact installed... now YOU know..:tiphat:

Originally Posted by b1adesofcha0s (Post 2197204)

How convenient, we're going to the track Saturday afternoon. It's open till 6 PM. :tup: