The New "What did you do with your Z today" (with off topic replies) IV

kenchan · 04-03-2013, 01:18 PM

race ramps also sell roll ups like this:

http://www.amazon.com/Chevrolet-Corv...=race+ramp+low

kenchan · 04-03-2013, 01:26 PM

for mr.gale- post # 1238

The Alphabet Category Game -- Part II

ZMan8 · 04-03-2013, 01:35 PM

Quote:

Originally Posted by JARblue

I have been thinking about this for a while, just haven't actually done it. I contemplated full size wooden ramps, but have since decided I just need some small ones to get the front end high enough to clear my jack

They're like really low height ramps that you drive up on, right? I think I need closer to 3-4" but I will check tonight. I don't really have need for them since I don't store the car, but if the price is right...

Mine right now are about 3-4" high, but I think a better height is 5-6". to get that you need about 3 planks of wood.

kenchan · 04-03-2013, 01:41 PM

too bad my garage has this step at the back of the garage where the front ends of my G and Z are parked. due to this, i cant roll my hydraulic under the car from the front.

JARblue · 04-03-2013, 01:42 PM

Quote:

Originally Posted by ZMan8

Mine right now are about 3-4" high, but I think a better height is 5-6". to get that you need about 3 planks of wood.

I am hoping to get away with two pieces stacked, but we shall see... my low profile jack is pretty close to being able to fit already (it hits the chin spoiler at the very back of the jack near where the handle attaches).

ZMan8 · 04-03-2013, 01:43 PM

Quote:

Originally Posted by kenchan

too bad my garage has this step at the back of the garage where the front ends of my G and Z are parked. due to this, i cant roll my hydraulic under the car from the front.

I park in reverse when I put the Z on Jack stands since the front requires more room to jack it up (lower clearance and need to get the jack way under there)

JARblue · 04-03-2013, 01:43 PM

Quote:

Originally Posted by kenchan

too bad my garage has this step at the back of the garage where the front ends of my G and Z are parked. due to this, i cant roll my hydraulic under the car from the front.

I have a step, too, but there is plenty of room provided I don't pull the Z too far forward

ZMan8 · 04-03-2013, 01:43 PM

Quote:

Originally Posted by JARblue

I am hoping to get away with two pieces stacked, but we shall see... my low profile jack is pretty close to being able to fit already (it hits the chin spoiler at the very back of the jack near where the handle attaches).

you're not lowered

JARblue · 04-03-2013, 01:50 PM

Quote:

Originally Posted by ZMan8

you're not lowered

Nope, and I have no plans to do so

I would be open to adjustable coilovers, but that's not in the cards until I commit to regular track time.

Pintsize725 · 04-03-2013, 01:50 PM

Quote:

Originally Posted by JARblue

I have a step, too, but there is plenty of room provided I don't pull the Z too far forward

Looks like I've got a lot and not sure what I'll do just yet. So, when do you want me to stop by? Maybe you can help me figure out if my front bumper paint is cured yet?

ZMan8 · 04-03-2013, 01:51 PM

Quote:

Originally Posted by JARblue

Nope, and I have no plans to do so

I would be open to adjustable coilovers, but that's not in the cards until I commit to regular track time.

Makes sense since you dd yours

JARblue · 04-03-2013, 01:56 PM

Quote:

Originally Posted by Pintsize725

Looks like I've got a lot and not sure what I'll do just yet. So, when do you want me to stop by? Maybe you can help me figure out if my front bumper paint is cured yet?

When do you want to come by? Anytime this week in the evening should be fine. I want some more Onyx at some point, but I need to check a couple of things before I decide how much I need.

Quote:

Originally Posted by ZMan8

Makes sense since you dd yours

And that would be the reason why. Hell, I already scrape my driveway if I enter at the wrong angle, and it's not even that steep.

Pintsize725 · 04-03-2013, 01:59 PM

Quote:

Originally Posted by JARblue

When do you want to come by? Anytime this week in the evening should be fine. I want some more Onyx at some point, but I need to check a couple of things before I decide how much I need.

And that would be the reason why. Hell, I already scrape my driveway if I enter at the wrong angle, and it's not even that steep.

I can stop by whenever this week. Let me know how much you need and I'll get a price.

kenchan · 04-03-2013, 02:03 PM

Quote:

Originally Posted by ZMan8

I park in reverse when I put the Z on Jack stands since the front requires more room to jack it up (lower clearance and need to get the jack way under there)

that sounds good, mr.zman!

i suppose i could do that but my tool case is right up at the ledge so my rear bumper could hit it to make enough room to roll up the roll-up ramp.

Quote:

Originally Posted by Pintsize725

I can stop by whenever this week. Let me know how much you need and I'll get a price.

oh those blocks are not free...

JARblue · 04-03-2013, 02:06 PM

Quote:

Originally Posted by Pintsize725

I can stop by whenever this week. Let me know how much you need and I'll get a price.

I'm thinking five squares per door, plus another five squares for leftovers and a couple more locations in the hatch. The question is whether I do the roof as well. I am currently attempting to get the roof lining replaced under warranty, so I will have that done at the same time. Or I could use the 80 mil product that I have. Idk yet...

04-03-2013, 01:26 PM	#9062 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141520	for mr.gale- post # 1238 The Alphabet Category Game -- Part II GaleForce likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The New "What did you do with your Z today" (with off topic replies) III	happytheman	The Lounge (Off Topic)	9956	02-10-2013 02:13 PM
The New "What did you do with your Z today" (with off topic replies) II	happytheman	The Lounge (Off Topic)	10004	12-24-2012 07:31 PM
The New "What did you do with your Z today" (with off topic replies)	happytheman	The Lounge (Off Topic)	10265	10-31-2012 11:15 PM
We learned a valuable lesson about the "VDC OFF" button today thanks to b1ades	birdmanx1	Mid-Atlantic Region	167	09-01-2011 09:50 AM
got to autocross a couple different"high end" cars today	MC	Other Vehicles	15	06-13-2009 07:48 PM

04-03-2013, 01:18 PM	#9061 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141520	race ramps also sell roll ups like this: http://www.amazon.com/Chevrolet-Corv...=race+ramp+low

04-03-2013, 01:41 PM	#9064 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141520	too bad my garage has this step at the back of the garage where the front ends of my G and Z are parked. due to this, i cant roll my hydraulic under the car from the front.