Installing z1 intake manifold

exsanity · 09-30-2014, 04:17 PM

Disclaimer: The following information is intended for reference material only. Refer to the Service Data and Specifications table "Tightening Torque" in the EM section of the applicable Factory Service Manual for your model year Z.

Quote:

Originally Posted by Service Manual

INTAKE MANIFOLD COLLECTOR
• If stud bolts were removed, install them and tighten to the torque specified below.

: 10.8 N·m (1.1 kg-m, 8 ft-lb)

• Tighten mounting bolts and nuts in numerical order as shown in the
figure.

As found in >this< post.

jamesj1996 · 09-30-2014, 04:20 PM

Quote:

Originally Posted by exsanity

Disclaimer: The following information is intended for reference material only. Refer to the Service Data and Specifications table "Tightening Torque" in the EM section of the applicable Factory Service Manual for your model year Z.

As found in >this< post.

thanks so much and whats the order it needs to be in can u post a pic?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Upper Intake Manifold	DIGItonium	Forced Induction	10	12-03-2013 03:56 PM
ID this intake manifold	Japanjay	Intake/Exhaust	5	07-27-2013 07:31 PM
[FOR SALE] OEM intake manifold	seymore4	Parts for sale (Private Classifieds)	5	02-24-2012 06:17 PM
Motordyne Intake Manifold on the way!!	GZ3	Intake/Exhaust	67	09-16-2010 12:49 AM
Revshift Intake Manifold	Jamaica	Intake/Exhaust	22	07-13-2010 11:34 PM