Depressing story, help with my fi exhaust

shayandude · 12-16-2012, 08:27 AM

So the super sweet fi exhaust with carbon cans and 18 inch resonators came to me couple weeks ago. I love it, couldent be happier, until I bottomed out leaving a parking lot couple nights ago, and not only did It scuff the bottom of the carbon cans up a good bit, where the cans start is now leaking. Any help or ideas of what to do?
Is the carbon cans carbon all the way through? Or is it stainless steel and carbon wrapped? Thanks in advance, it almost makes a grown man want to cry. Sucks

Jasonle · 12-16-2012, 08:33 AM

damn that sucks...I know how you feel..I accidentally ran over a curb and my top speed exhaust was dented. very sad day

shayandude · 12-16-2012, 09:07 AM

Yeah n I'm still paying for these, n sure can't afford new cans

Nut_N_Much · 12-16-2012, 09:39 AM

I have scratches on mine two thanks to my

wife.. I email FI and asked about replacing the back half they quoted aprox $850.00 to replace the cans.

Also I asked about drilling out the rivets and repairing the seal. With the CF cans the CF is the can , no stainless or anything under it, just the baffles, inlet, outlet. I think it could be fixed but it would take some work to pull them apart. There is a grey rubber gasket that runs around the edges; if its damaged we would have to replace it with something. FI doesn't supply them.

Also you can sand down the CF to get it smooth and apply some resin. Sander her smooth and reinstall. I am planning on doing mine next year. If I don't get a replacement system.

Wile you research this please let me know if you figure out a way to fix them.

shayandude · 12-16-2012, 10:02 AM

Ah man, that's expensive and makes me regret the cf. yikes. No luck yet, hopefully tomorrow with my buddy I'm gonna jack the car up and raise my coil overs so its not so low, and take the cans off and try and study them, from what another buddy has told me, most likely it's leaking at a flange, so ill have to replace a gasket and or silicone it real good. Or if its on the actual can to tig weld it. So only time will tell.. Horrible horrible. Ill keep u posted either by pm or on this thread

FairladyZ · 12-16-2012, 11:01 AM

Hai you so sure it's leaking

blueranger · 12-16-2012, 11:25 AM

Sorry to hear hope you can find a fix... How low is your car?

NBZ34 · 12-16-2012, 11:50 AM

So sorry to hear about the hole in your CF cans. Yeah, the entire can is CF, which is why I chose to order the SS cans... for durability.

Hope you find a relatively inexpensive way to fix them!

shayandude · 12-16-2012, 12:55 PM

It's dropped a good boy, not too low, but probably 1 1/2 inches. I'm sure it's leaking. I cranked the car up, and got under it, and where the cans start, it's leaking air
Out.

shayandude · 12-16-2012, 12:57 PM

Thanks Guys, doesn't seem to be looking too good, so I don't know what my portions are at this point. Gonna take it off tomorrow and see what I can figure out.

Nut_N_Much · 12-16-2012, 01:29 PM

Take some pictures when you get them off. I'm interested to see the damage, some folks here may be able to offer up a solution. Keeping fingers crossed

Trips · 12-16-2012, 01:49 PM

Your options are to have a muffler shop seal it or give Tony a call and see if he can work something out with a replacement.

shayandude · 12-16-2012, 02:10 PM

Yea, replacement might be out of question, another member was quoted 850. So def can't take that route

XwChriswX · 12-16-2012, 04:12 PM

Quote:

Originally Posted by shayandude

Yea, replacement might be out of question, another member was quoted 850. So def can't take that route

You can check the FS sections and see if someone is selling a Used FI Exhaust, and just scavenge parts or buy another kit and sell yours.

shayandude · 12-16-2012, 04:26 PM

I'm about to take the cans off now before it gets dark ill post pics as soon as I can

12-16-2012, 08:27 AM	#1 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	Depressing story, help with my fi exhaust So the super sweet fi exhaust with carbon cans and 18 inch resonators came to me couple weeks ago. I love it, couldent be happier, until I bottomed out leaving a parking lot couple nights ago, and not only did It scuff the bottom of the carbon cans up a good bit, where the cans start is now leaking. Any help or ideas of what to do? Is the carbon cans carbon all the way through? Or is it stainless steel and carbon wrapped? Thanks in advance, it almost makes a grown man want to cry. Sucks

12-16-2012, 08:33 AM	#2 (permalink)
Jasonle A True Z Fanatic Join Date: Jan 2011 Location: St. Louis Posts: 3,509 Drives: 09 370z Rep Power: 25	damn that sucks...I know how you feel..I accidentally ran over a curb and my top speed exhaust was dented. very sad day __________________ 2009 Nissan 370z/2003 Honda Soccer Van Shineauto Amuse Body Kit/UAM Fenders/Bc Br Coilovers/Topspeed Exhaust/Racing Hart Wheels and More My Sexy Beast

12-16-2012, 09:39 AM	#4 (permalink)
Nut_N_Much A True Z Fanatic Join Date: Dec 2011 Location: Pensacola Florida Posts: 1,696 Drives: Awesome Car Rep Power: 26	I have scratches on mine two thanks to my wife.. I email FI and asked about replacing the back half they quoted aprox $850.00 to replace the cans. Also I asked about drilling out the rivets and repairing the seal. With the CF cans the CF is the can , no stainless or anything under it, just the baffles, inlet, outlet. I think it could be fixed but it would take some work to pull them apart. There is a grey rubber gasket that runs around the edges; if its damaged we would have to replace it with something. FI doesn't supply them. Also you can sand down the CF to get it smooth and apply some resin. Sander her smooth and reinstall. I am planning on doing mine next year. If I don't get a replacement system. Wile you research this please let me know if you figure out a way to fix them. __________________ Did new cool science stuff to the car !!! http://www.the370z.com/mazoc/99606-z...y-14-17-a.html http://www.the370z.com/diy-section-d...-w-videos.html

12-16-2012, 11:50 AM	#8 (permalink)
NBZ34 Enthusiast Member Join Date: Jan 2012 Location: New Braunfels, TX Age: 53 Posts: 467 Drives: '12 Touring AT Sport Rep Power: 13	So sorry to hear about the hole in your CF cans. Yeah, the entire can is CF, which is why I chose to order the SS cans... for durability. Hope you find a relatively inexpensive way to fix them! __________________ *CHRIS* 開田 2012 370Z MB Touring/Sport/AT/Nav \| Takeda \| Fast Intentions \| SWIFT \| H&R \| UpRev \| Michelin PSS \|

12-16-2012, 01:29 PM	#11 (permalink)
Nut_N_Much A True Z Fanatic Join Date: Dec 2011 Location: Pensacola Florida Posts: 1,696 Drives: Awesome Car Rep Power: 26	Take some pictures when you get them off. I'm interested to see the damage, some folks here may be able to offer up a solution. Keeping fingers crossed __________________ Did new cool science stuff to the car !!! http://www.the370z.com/mazoc/99606-z...y-14-17-a.html http://www.the370z.com/diy-section-d...-w-videos.html

12-16-2012, 09:07 AM	#3 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	Yeah n I'm still paying for these, n sure can't afford new cans

12-16-2012, 10:02 AM	#5 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	Ah man, that's expensive and makes me regret the cf. yikes. No luck yet, hopefully tomorrow with my buddy I'm gonna jack the car up and raise my coil overs so its not so low, and take the cans off and try and study them, from what another buddy has told me, most likely it's leaking at a flange, so ill have to replace a gasket and or silicone it real good. Or if its on the actual can to tig weld it. So only time will tell.. Horrible horrible. Ill keep u posted either by pm or on this thread

12-16-2012, 11:01 AM	#6 (permalink)
FairladyZ Track Member Join Date: Jan 2009 Location: Los Angeles Posts: 850 Drives: 2012 370Z TRNG SPRT Rep Power: 17	Hai you so sure it's leaking

12-16-2012, 11:25 AM	#7 (permalink)
blueranger Track Member Join Date: Aug 2012 Location: Albuquerque NM Posts: 577 Drives: 2010 Roadster 7AT Rep Power: 306	Sorry to hear hope you can find a fix... How low is your car?

12-16-2012, 12:55 PM	#9 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	It's dropped a good boy, not too low, but probably 1 1/2 inches. I'm sure it's leaking. I cranked the car up, and got under it, and where the cans start, it's leaking air Out.

12-16-2012, 12:57 PM	#10 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	Thanks Guys, doesn't seem to be looking too good, so I don't know what my portions are at this point. Gonna take it off tomorrow and see what I can figure out.

12-16-2012, 01:49 PM	#12 (permalink)
Trips Administrator Join Date: May 2009 Location: Disneyland, Ca Posts: 8,728 Drives: 🔰 Rep Power: 10	Your options are to have a muffler shop seal it or give Tony a call and see if he can work something out with a replacement. Nut_N_Much likes this. __________________

12-16-2012, 02:10 PM	#13 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	Yea, replacement might be out of question, another member was quoted 850. So def can't take that route

12-16-2012, 04:26 PM	#15 (permalink)
shayandude Base Member Join Date: Jun 2012 Location: louisiana Posts: 153 Drives: 07 350z, 09 pw 370z Rep Power: 12	I'm about to take the cans off now before it gets dark ill post pics as soon as I can Nut_N_Much likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
My Z Story =]..	Mr. Z	Nissan 370Z General Discussions	18	05-17-2012 08:57 AM
New Story	RiCharlie	The Lounge (Off Topic)	15	12-07-2011 07:57 AM
Possible to start engine without depressing on clutch??	MBLAQ	Nissan 370Z General Discussions	29	11-15-2010 07:09 AM
An eBay Parts Story -- 370z Exhaust System	onzedge	Intake/Exhaust	8	06-28-2010 01:37 PM
my story	destinyZ	New 370Z Owner	6	05-01-2010 04:29 PM