Fast Intentions exhaust is here!

steveg78

Looks good can't wait til mine come in!
The tips look a little off-centered though. The left side I noticed most. Is this what the washer trick fixes? I'm an anal-mofo and I will be doing the install myself so I just want to know if aligning the tips perfectly centered in the exhaust cutouts of the rear valance requires the washer trick?

Thks

nashtyboy

I must have been slightly off-center when I took the pic, because the exit pipes do appear to line up perfectly. We ended up tweaking the right hangar just a tad down to get them lined up, since that pipe was just a touch higher.

During install, the left pipe didn't line up quite perfectly, so the left rez ended up being a touch lower than the right which kind of sucks, but the exit pipes look fine. We tried loosening everything on the left side & making sure it was as high as possible before re-tightening, but the bolts all fit nice and snug, so there was really nowhere else for the pipe to go.

steveg78

Did you just bend the hangar? I hear they are hard to bend. Just trying to be prepared because I will be doing the install myself as the base where I work has garages and lifts at the auto crafts center that I can use

nashtyboy

Yeah we just bent it a touch with a vice grip. A couple washers would have done the trick as well.