Interest Thread: AAM Competition 2.5" H-Pipe + Res Mid-pipe to shorties or stock rear

[b1adesofcha0s]

Originally Posted by 370ZNISMO#704

Khoi if there could be some awesome deal worked out I could run a few different variations on my Nismo. As it sits I have my own custom made short tails and GENIII CAI. All stock besides that.
With the setup of just short tails I made 296.1 was my lowest of 3 pulls I have not re dynoed yet with the CAI yet.
I still have my oem Nismo muffler I could do a dyno with the new H-pipe to Nismo rear and then to my shorties also do a base pull with the Nismo exhaust completely back to oem.
Let me know if I can be of any help.

If you don't mind me asking, how much did it cost you to get those custom short tails made? I'm thinking about doing the same to fit with my berk CBE.

[370ZNISMO#704]

Originally Posted by b1adesofcha0s

If you don't mind me asking, how much did it cost you to get those custom short tails made? I'm thinking about doing the same to fit with my berk CBE.

No worries it was a little expensive just because all the bends are pie cuts and the custom angle down tip is all pie cut as well so there is no mandrel bends at all. But it was 425 I believe it was over a yr plus ago. I think in my pics I have some good clear pics of them. I like them because there one off.
Cheers!!

[b1adesofcha0s]

Originally Posted by 370ZNISMO#704

No worries it was a little expensive just because all the bends are pie cuts and the custom angle down tip is all pie cut as well so there is no mandrel bends at all. But it was 425 I believe it was over a yr plus ago. I think in my pics I have some good clear pics of them. I like them because there one off.
Cheers!!

Yeah that does seem a bit expensive. Hopefully I can get it done for less, but thanks!