Lost power in take off after motordyne m370
 

Guys,
:( I lost take off power after installing motordyne m370 intake manifold.
Anyone got the same problem.

the dynos show that.. tune it and you can pretty much get it back to stock levels and pick up power up top..

You think I should take it off :(

the engine has to be tuned for the increased air flow. it's running lean down low now, it sounds like.

HKYStormFront,
Do you think unichip will do the trick

honestly, i'm not sure. i don't know what all unichip does. i'm only really familiar with Uprev tuning since i have it on my truck. hopefully someone who knows will be able to answer your question...

Thanks very much bro

You picked up mid range torque; with tuning you'll break about even in peak..

Get Osiris uprev and dyno tune the car.

UH OH, sounds like someone didn't do his research before modding his car. You a need a tune bro. Get uprev and all will be good again. Do it quick to before you do damage to the engine.

Yep, do an uprev tune and you will feel a new car under your azz!

I have the same issue and I'm untuned. Part of it is due to a busted O2 sensor so I'm super rich to the point of back fire on light throttle inputs. I'll be fixing it this weekend.

Will do that bro's thanks for the input.

Do you think guys unichip will be good. I've had it before and did get nice HP

I wouldn't mess with any ECU tune software unless it was from Uprev with these vehicles right now.

Ok uprev will be on my car this weekend.
Thanks guys