Hi aalqaedi

Pm me , will guide you where to tune in UAE

What other mods you have on the car ?!?! Exhaust, intake ?!?!

Guys I got the dyno sheet I will post it today. I have it on my iPad and I don't know how to upload from I pad.
It was 234 whp and 197 wtq :(
The car is right not lean as I though.
So this is what I will do:
1- I will put invida test pipe
2- reinstall the m370 intake manifold and check the seal
3- check the O2 sensor
Any thing els I have to do guys
Thanks in advance ;)

Guys I got the dyno sheet I will post it today. I have it on my iPad and I don't know how to upload from I pad.
It was 234 whp and 197 wtq
The car is right not lean as I though.
So this is what I will do:
1- I will put invida test pipe
2- reinstall the m370 intake manifold and check the seal
3- check the O2 sensor
Any thing els I have to do guys
Thanks in advance

what kind of dyno? those are some pretty low numbers..

It is mustang dynamoter

I will post it today.

The seal is super important. Make sure the bolts aren't cross threaded and seated square on the plate.

guys this is the dyno chart. Advice if you can see any problem :(
tb6pa.jpg at Free Image Hosting

Guys this is pic of my 370Z and G35coupe

Guys this is pic of my 370Z and G35coupe
jmhjv.jpg at Free Image Hosting

The dyno chart looks normal. You have good midrange torque which the M370 gives and the numbers are reasonable from a Mustang dyno. I have CAI, HFC, CBE and lightweight pulley with an M370 intake and UpRev tune on a Mustang dyno which my numbers also show. Most people with the same mods on a DynoJet are seeing around 320whp. The numbers are nice to look at, but how does it feel? Mine felt like night and day after the M370 UpRev tune.

Well the guys at the tuning shop did not tune the car because they felt something isnt right about the reading.
So this chart without the tuning.
Do you think that I should go and do the tuning?

Well the guys at the tuning shop did not tune the car because they felt something isnt right about the reading.
So this chart without the tuning.
Do you think that I should go and do the tuning?

A tune should smooth out the jagged edges.

This is my Mustang Dyno chart. The lower set of lines are a base run and the higher set are with all installed mods and UpRev tune.

http://www.the370z.com/attachment.ph...1&d=1341950901