|
The stock curve was similar but the Weldina gave about 4-6hp and 4-6tq from 3000-4500 and 5000-6500. Peak horsepower was still about 275hp and 230tq. Basically a midrange boost. The
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
02-27-2011, 04:36 PM
|
#9 (permalink) |
|
Track Member
Join Date: May 2010
Location: GA
Posts: 882
Drives: 2010 370Z BS M6
Rep Power: 17  |
The stock curve was similar but the Weldina gave about 4-6hp and 4-6tq from 3000-4500 and 5000-6500. Peak horsepower was still about 275hp and 230tq. Basically a midrange boost. The problem with the Weldina is that going into the Y-section it necks down to a single 2.5" pipe and then comes back out into two 2" pipes. The exhaust stays at 2" all the way through the resonators and then jumps back up to 2.5" through the rear exits. I used a 304 stainless 2010 Mustang X-pipe and some Vibrant 2-1/2" stainless resonators to make a full 2.5" system with the Weldina muffler in the back. Much smoother after dropping out that midsection and replacing with a proper 2-1/2" full x-pipe.
__________________
2013 Ford Mustang GT 374rwhp, 360rwtq SAE / GT500 Axle-Backs / Brembo Pack / Track Pack / Recaros / 6spd Last edited by '10Anamoly; 02-27-2011 at 04:39 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AAM Comp. Exhaust Sale: 2.5" and 3'' True Dual Exhaust Exhaust, HFC and Test Pipes! | Rob@Altered | Exhaust/Intake | 33 | 04-02-2012 07:03 PM |
| 370z TANABE EXHAUST and Y PIPE DYNO and VIDS | htt760 | Intake/Exhaust | 56 | 03-23-2011 07:11 PM |
| JDM Y pipe and test pipes? | njustidokite | Intake/Exhaust | 2 | 12-03-2010 08:12 AM |
| Dyno Request: F.I. Test Pipes + F.I. TDX CBE | labk888 | Intake/Exhaust | 2 | 04-29-2010 12:56 AM |
| Stillen exhaust with X-pipe + custom tips | DannyGT | Intake/Exhaust | 23 | 05-26-2009 04:13 PM |
Threaded Mode
