CEL with ART pipes

CyberKnup · 05-07-2021, 12:56 PM

Getting the following codes
P0136
P0156

Codes came about 25 miles after ART pipe install

I get the following readings for the Heated O2 sensors voltage seen in the screenshot attached which, from what I can tell, is within spec from a little googling.

Any idea what I should check first? Can this be caused by an exhaust leak?

2011 Nismo#91 · 05-10-2021, 05:24 AM

Check your tune, that should all be disabled.

CyberKnup · 05-10-2021, 09:14 PM

Quote:

Originally Posted by 2011 Nismo#91

Check your tune, that should all be disabled.

I emailed Seb and this is what he told me

"That’s for the actual sensors. Something is up. Those are NOT typical for test pipe install. Usually it’s a P0420 and 430. Also the P2096 and 2098."

Spooler · 05-10-2021, 09:32 PM

Did you use an impact removing the cats? If you did, you screwed them up. Replace them. They are very sensitive.

CyberKnup · 05-10-2021, 09:36 PM

Quote:

Originally Posted by Spooler

Did you use an impact removing the cats? If you did, you screwed them up. Replace them. They are very sensitive.

Nah, no impact was used, we hand removed everything and hand tightened. Could be that I overtightened though, I wasn't following any torque spec because I'm an idiot

Spooler · 05-10-2021, 10:18 PM

Quote:

Originally Posted by CyberKnup

Nah, no impact was used, we hand removed everything and hand tightened. Could be that I overtightened though, I wasn't following any torque spec because I'm an idiot

Noop, you should be good on those unless you dropped them.

CyberKnup · 05-10-2021, 11:40 PM

Quote:

Originally Posted by Spooler

Noop, you should be good on those unless you dropped them.

Didn't drop them, but I did put them on the ground.

So can an exhaust leak at the art pipes cause it? I need to go back under the car and re-torque all the bolts down since it has been on the car for a bit now.

05-10-2021, 05:24 AM	#2 (permalink)
2011 Nismo#91 A True Z Fanatic Join Date: Mar 2011 Location: NJ Posts: 2,381 Drives: slowly Rep Power: 33858	Check your tune, that should all be disabled. __________________ GTR TT 493Whp/431lbft, Ecutek, Southbend 6puck,Quaife, RPM RollBar 4Point, R888R, JRZ RSPro F(10R/10C) R(10R/6C) 1000f500r inlbs+150inlbs Tender, SPL everywhere.Full Specs

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
370z Midpipes/Down Pipes/Y-Pipes/Test Pipes and HFC!! Best Prices in town!	JM Auto Racing	Exhaust/Intake	472	11-28-2022 12:57 PM
Motordyne Art Pipes and Y Pipes IN STOCK @ ZSpeed!	Joe@ZSpeed	Exhaust/Intake	1	03-15-2016 02:55 PM
FOR SALE - Z1 Motorsports 350Z--370Z HR SS Test Pipes (aka Down Pipes)	leilaamurray	New Forum Member	1	10-10-2012 08:12 PM
Long Tube Headers vs HFC vs Test Pipes vs Art Pipes	NickD	Intake/Exhaust	16	06-30-2012 02:24 PM

05-10-2021, 09:32 PM	#4 (permalink)
Spooler A True Z Fanatic Join Date: Jun 2014 Location: Ga Posts: 13,518 Drives: 2013 Nismo 370z Rep Power: 2684391	Did you use an impact removing the cats? If you did, you screwed them up. Replace them. They are very sensitive.