FI LTH.. when?

kdo2milger · 12-11-2009, 10:21 AM

Tony thank you for the update!

i am impressed that you want to go the distance with this project to ensure the best possible gains across the board...

highly respectable and look forward to the results of the next phase

RCZ · 12-11-2009, 12:24 PM

Quote:

Originally Posted by semtex

The Stillen headers did the same thing. I'm not surprised. It's because the stock manifold has unequal length tubing. When you replace those with equal length tubing, the smooths out the sound somewhat.

Are you sure the stockers are UL? This being a V6...UL headers cause pulse crams that negatively affect performance. I would think Nissan put EL headers from the start, I was under that impression.

Quote:

Originally Posted by Red370

Well the fact that the Stillen headers by themselves make between 10-15hp, and the fact that these headers eliminate the cats which see gains of 10-15hp, leads me to believe that these headers should make substantial gains, probably closer to 20whp. My old Eclipse GT with the RIPP long tubes with a tune netted me 38whp, so I dont see why these wouldnt make quite a bit of juice.

Stillen headers did not make 10-15hp. I'm not even looking for more than 5whp from the FI, I'm only looking for how much torque they will pickup...since thats apparently LTH's claim to fame.

Quote:

Originally Posted by kdo2milger

Tony thank you for the update!

i am impressed that you want to go the distance with this project to ensure the best possible gains across the board...

highly respectable and look forward to the results of the next phase

Highly respectable that he does research on a product he is developing? come on, he is doing what he is supposed to do.

semtex · 12-11-2009, 03:27 PM

Quote:

Originally Posted by RCZ

Are you sure the stockers are UL? This being a V6...UL headers cause pulse crams that negatively affect performance. I would think Nissan put EL headers from the start, I was under that impression.

I'm ~fairly~ certain. I seem to recall getting that from Josh, but it's been so long I can't say I'm 100% on this. So take it with a grain of salt, I guess. If the stockers are EL, then I'm not sure what the advantage of aftermarket headers would be, at least in terms of regular-length ones. I don't think they're wider diameter piping, are they?

12-11-2009, 10:21 AM	#1 (permalink)
kdo2milger OG Priesthood Join Date: Feb 2009 Location: Fargo, ND Posts: 17,859 Drives: NISMO T Rep Power: 61	Tony thank you for the update! i am impressed that you want to go the distance with this project to ensure the best possible gains across the board... highly respectable and look forward to the results of the next phase __________________ Project *NISMO*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode