Boosted Performance V 2.0

6mt370 · 11-09-2015, 04:35 AM

Praying that the oil feed port is facing the right way. Someone please tell me that's correct lol. If it is then I'm right on track. Very fun install minus a few headached parts that don't want to cooperate cough cough oil pan. Lol. Pretty close to buttoning everything up. A few more nights with 3-4 hours should do the trick. Thanks for the help guys. Oh and Sasha, everything is spot on fitting wise except for the IC bracket on the pass side. I'll have to re drill it a little to get it to fit properly.
I do have one question for you guys. My pipes are all wrapped and idk if that's the problem but I had to remove the heat shield from the pass side to get the turbo piping to fit. There was a stud protruding way to much and we pretty much had to remove it, and it's still very close to rubbing the floor board. Maybe a few MM's. Other than that all is good.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boosted Performance turbo kit self install (review)	Cell	Forced Induction	87	10-24-2017 09:38 AM
Boosted Performance round 2 list	Boosted Performance	Forced Induction	1480	06-03-2014 08:44 AM
Joepro's Boosted Performance build thread!	Joepro	Member's 370Z Gallery	82	04-16-2014 11:09 AM
For you guys that want to know what the Boosted Performance kit sounds like :)	Mitco39	Nissan 370Z Photos / Spyshots / Video / Media Gallery	5	04-10-2013 01:26 PM

11-09-2015, 04:35 AM	#33 (permalink)
6mt370 Base Member Join Date: May 2015 Location: House Posts: 207 Drives: 370 Rep Power: 11	Praying that the oil feed port is facing the right way. Someone please tell me that's correct lol. If it is then I'm right on track. Very fun install minus a few headached parts that don't want to cooperate cough cough oil pan. Lol. Pretty close to buttoning everything up. A few more nights with 3-4 hours should do the trick. Thanks for the help guys. Oh and Sasha, everything is spot on fitting wise except for the IC bracket on the pass side. I'll have to re drill it a little to get it to fit properly. I do have one question for you guys. My pipes are all wrapped and idk if that's the problem but I had to remove the heat shield from the pass side to get the turbo piping to fit. There was a stud protruding way to much and we pretty much had to remove it, and it's still very close to rubbing the floor board. Maybe a few MM's. Other than that all is good.