My 1 s3xy z stilled SC build.

Mkai0

Good choice, I left my buddy's Stillen SC'd car like he was standing still. After a few runs he wanted to buy the GTM stage 2 to one up me! Go figure

__________________
Eibach, Tanabe, Blitz, Vertini, GTM stage 1.5 SC, Aquamist, Invidia, Alto built 5AT, Edge Racing, Racelogic, GTM driveshaft, 440 whp in 101F TX heat..

ANMVQ

Yea go figure the GTM STG 2 makes more PSI and the Stillen kit, Stillen's kit is = to GTM STG-1. If you didnt walk him hard they would be something wrong,

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

Mkai0

He has a Stillen G37 SC'd Sedan, and I have GTM SC'd Stage 1 HR G35 Sedan. To my knowledge an HR motor has to run higher psi in order to achieve the same HP level as a VHR, two different beasts. I am using a pulley that gets me roughly 9-10 psi, and he was seeing 8-9. I know for a fact that I am putting down at least 30 more torque than him, which definitely gives me an advantage even though we have similar horsepower numbers. We were also tuned by the same tuner.

__________________
Eibach, Tanabe, Blitz, Vertini, GTM stage 1.5 SC, Aquamist, Invidia, Alto built 5AT, Edge Racing, Racelogic, GTM driveshaft, 440 whp in 101F TX heat..

indyn

what are yours and yours friends HP/Torque numbers on the same dyno?

Mkai0

He was putting down roughly 365hp/290tq SAE and I put down roughly 362hp/322tq SAE. Both tuned with Uprev and AT trans. The numbers we put down on the dyno were after being tuned and heatsoaked.

__________________
Eibach, Tanabe, Blitz, Vertini, GTM stage 1.5 SC, Aquamist, Invidia, Alto built 5AT, Edge Racing, Racelogic, GTM driveshaft, 440 whp in 101F TX heat..

ANMVQ

number look like the "OLD" Stillen kit, Since I made more power than both of you An this is why you told him good choice on going GTM?

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

weiboy718

Bro! DYNO numbers don't mean sh!t! Take it easy.