***Blackonorange's STS Turbo Build!! - Done by Speedtech Saskatoon***

blackonorange

K so guys , we took everything apart, the turbo the exhaust , everything checks out except for a frothy mess in the turbo , the ecu code was 0P005 ( I think, I forget the exact numbers) but it ment ECM failure so Itthrew the car into limp mode and dumped all the fuel out the exhaust? Does this even make sense? Does limp mode make our cars smoke ? Can some one tell me what happened? I erased the code and the car runs like a raped ape again, what's the deal? Any help is appreciated

hindi1973

our sts 370z has been having some error codes as well p1006 or something like that (sensor error) and check engine pops up again , we deleted it but it comes again , once on wot the car shut down by it self and smoked like hell for a sec when it shut off but once started again it never happened again, but the code is still their and we just accepted it as is and left it alone , the customer likes the kit , but we have been having boost leak issues , a couple of the exhaust couplers that were deleted and welded to fix the issue and stopping it from comin.

hope this helps

blackonorange

Hmmm weird , my code is gone now , but about the the exhaust leaks how did you find them? And that's basically what mine did I was wot and boom limp mode and smoke , the car stayed idling tho

hindi1973

we did a boost test leak by using the mechine the uses 2 methods first of all putting pressure in the intake by removing the air filter and placing it there and then after marking the leaks places by hearing them we use the second method which is white smoke (vaporized smoke ) to find little places that we might have missed , from wht i read the sensor in the intake doesnt take much pressure at once so it goes crazy their is a section in the uprev tuning in the DTC section to by pass it but we couldnt enter that section although the ecu is not locked but its limited for the tuner to enter everywhere unless he uploads the map from his wire which means the map in the car now gets deleted, the code we get is P0106 MAP/Barometric Pressure Circuit Range/Performance Problem, and regarding the crazy shut off dont know why it happened or if its attached to what i am mentioning above , but i could reassure you that my customer didnt have any problems with his gtm stage 1 kit , not even a check engine or anything just had coolent temps problems and thats due to our 130f minimum heat , not bashing here but just sharing real facts that have happened and ive seen them , again all kits are amazing , but i guess these 370z's are just too sensitive .