Achieving 600 RWHP

teknoprep

Build list to get 650 wheel hp reliably

AAM twin turbo upgraded with turbo smart actuators and blow off
AAM exhaust

Built motor - wiseco 9:1 / h rods / etc
Built trans - I have an auto and level 10 did it
Built rear

Fuel rails cj
Fuel return kit cj
Upgraded fuel pump
6AN fuel lines
Upgraded injectors 1000cc

Upgraded suspension bushings
Upgraded coilovers bc racing
19R30 335 tires on the back

Custom front bumper from Rowen - this allows for openings for coolers
Oil cooler on driver side 10 inch x 12 inch 10AN
Trans cooler on passenger side 10 inch x 12 inch 10AN
Upgraded radiator - CSF for manual triple pass since I have separate trans cooler

Cut and welded frame so we didn't have to hammer the frame to for AAM turbo kit

Recaro seats

Attached Images

2017-11-14.jpg (541.0 KB, 29 views)

Streetz

600whp on E85 is about the common go too, these day for stock engines. I ran mine daily at 700whp for about 15k miles. Ended up making more power later and still never ran into issues.

Quality of install and tuning needs to be perfect to accomplish this on the stock engine. No need for cooling mods other then oil cooler like you mentioned.

Fuel system CJM S1.SE, set of ID 1000's and a aero 340 pump (can do a walbro 450, but not needed)

Clutch and exhaust listed will work as listed.

From watching these cars for many years, people over build from my experience.
The stock engines are very strong when setup properly. I also tell people if your goal is under 650whp the stock engine will be more reliable is some ways.

Good luck