Forced Induction Compression Ratios

Hotrodz · 01-08-2020, 05:30 PM

Quote:

Originally Posted by Elmo370z

I pretty confident a properly sleeved block will be able to handle that abused far better then a closed deck block. Just ask your engine builder.

LMAO, I am counting on it! There is a lot of speculation and I am hopeful that better minds will prevail but so far there is little evidence. The one motor that I am familiar with that has sort of held up has constant over heating issues. I am not looking for four digit whp numbers or close to it. 700 to 750 and I am goo to go!

Sent from my SM-G965U using Tapatalk

Spooler · 01-08-2020, 06:00 PM

Quote:

Originally Posted by Hotrodz

LMAO, I am counting on it! There is a lot of speculation and I am hopeful that better minds will prevail but so far there is little evidence. The one motor that I am familiar with that has sort of held up has constant over heating issues. I am not looking for four digit whp numbers or close to it. 700 to 750 and I am goo to go!

Sent from my SM-G965U using Tapatalk

You should be fine. Only way to tell is try it and see. A redo is dang expensive.

Hotrodz · 01-08-2020, 06:11 PM

Quote:

Originally Posted by Spooler

You should be fine. Only way to tell is try it and see. A redo is dang expensive.

I hear ya! Just had to stir the pot a little. You have done your homework and so all you, I and Elmo can do is pay our money and take our chances! I am up for it regardless of outcome!!!

Sent from my SM-G965U using Tapatalk

Spooler · 01-08-2020, 06:22 PM

Quote:

Originally Posted by Hotrodz

I hear ya! Just had to stir the pot a little. You have done your homework and so all you, I and Elmo can do is pay our money and take our chances! I am up for it regardless of outcome!!!

Sent from my SM-G965U using Tapatalk

I hate redo's with a passion. The definition of insanity is doing the same thing over and over again expecting a different result each time.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Forced induction	Sneakernturbo	Northern California Region	1	08-08-2016 05:53 PM
Forced Induction at last !	Optimiser	Forced Induction	4	12-31-2015 07:39 AM
Forced induction	stiso	Northern California Region	8	11-28-2011 12:03 PM
Help don't want forced induction!!!!!	Mjthind	Engine & Drivetrain	64	05-04-2011 01:00 PM
Forced induction	Seth G	Forced Induction	13	04-09-2010 12:36 AM