Nissan 370Z Forum  

Preparation for the STILLEN supercharger

Today's testing went extremely well! We had a few goals today and quite a lot of data logging equipment inside the car. We were monitoring a lot of different data

Go Back   Nissan 370Z Forum > Nissan 370Z Tech Area > Engine & Drivetrain > Forced Induction


Like Tree1Likes

Reply
 
LinkBack Thread Tools Display Modes
Old 02-26-2010, 06:53 PM   #1 (permalink)
The370Z.com Sponsor
 
Kyle@STILLEN's Avatar
 
Join Date: Dec 2008
Location: Newport Beach
Posts: 626
Drives: Toyota Tundra
Rep Power: 307
Kyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond repute
Default

Today's testing went extremely well!

We had a few goals today and quite a lot of data logging equipment inside the car. We were monitoring a lot of different data points and wanted to put the car through stressful environments, high speed tests, hard launch tests and more to see how everything would perform. We are extremely proud to say that the test could not have been better. Steve was able to really lean on the car and push it hard. We started out with a few simple high speed runs to well over 120+ MPH. Then after that was done we switched over to a tight course to really load up the car and try to get it warm and pushing hard. Then finished up with some really hard driving and let the tires burn!!!

It was really good that we were able to test the supecharger on the automatic gearbox G37. It really proved that the gearbox could handle the power and we were all impressed with its performance. Smooth clean shifts every time and no hang ups at all. Most impressive was the performance during the abuse tests...You'll see the video's on that soon!

At the end of the day Steve commented on how impressed he was with the low-end performance and responsiveness. We all know that centrifugals are known for having a lag similar to turbo's but he was commenting on how impressed he was with the ability to stand on the throttle at lower RPM to aid the car in rotating through the corner. Which is something that he was very concerned about.

I will update this post later tonight with some photos and a short teaser video.

Here is the short teaser video that Josh shot on his Iphone...We know it's not super HD quality but it should be good for now. You can see everyone standing around with cameras and what not we will edit the footage next week when things slow down a little.

http://bit.ly/cPa4Ha

Last edited by Kyle@STILLEN; 02-26-2010 at 07:30 PM.
Kyle@STILLEN is offline   Reply With Quote
Old 02-26-2010, 07:26 PM   #2 (permalink)
A True Z Fanatic
 
Red370's Avatar
 
Join Date: Jul 2009
Location: Kaiserslautern, Germany
Posts: 4,391
Drives: your mom to church
Rep Power: 297
Red370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond reputeRed370 has a reputation beyond repute
Default

Quote:
Originally Posted by Kyle@STILLEN View Post
Today's testing went extremely well!

We had a few goals today and quite a lot of data logging equipment inside the car. We were monitoring a lot of different data points and wanted to put the car through stressful environments, high speed tests, hard launch tests and more to see how everything would perform. We are extremely proud to say that the test could not have been better. Steve was able to really lean on the car and push it hard. We started out with a few simple high speed runs to well over 120+ MPH. Then after that was done we switched over to a tight course to really load up the car and try to get it warm and pushing hard. Then finished up with some really hard driving and let the tires burn!!!

It was really good that we were able to test the supecharger on the automatic gearbox G37. It really proved that the gearbox could handle the power and we were all impressed with its performance. Smooth clean shifts every time and no hang ups at all. Most impressive was the performance during the abuse tests...You'll see the video's on that soon!

At the end of the day Steve commented on how impressed he was with the low-end performance and responsiveness. We all know that centrifugals are known for having a lag similar to turbo's but he was commenting on how impressed he was with the ability to stand on the throttle at lower RPM to aid the car in rotating through the corner. Which is something that he was very concerned about.

I will update this post later tonight with some photos and a short teaser video.
__________________
2011 Mustang 5.0 | 3.55's | Lethal Performance off road H-Pipe | Magnaflow Muffler Delete | JLT CAI/Bama tuned 417whp/ 404 ft/lbs
Red370 is offline   Reply With Quote
Old 02-26-2010, 07:30 PM   #3 (permalink)
The370Z.com Sponsor
 
Kyle@STILLEN's Avatar
 
Join Date: Dec 2008
Location: Newport Beach
Posts: 626
Drives: Toyota Tundra
Rep Power: 307
Kyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond reputeKyle@STILLEN has a reputation beyond repute
Default

updated post #610 with video...

Preparation for the STILLEN supercharger
Kyle@STILLEN is offline   Reply With Quote
Old 02-26-2010, 08:17 PM   #4 (permalink)
Enthusiast Member
 
Join Date: Mar 2009
Location: So Cal
Posts: 303
Drives: 08 Infiniti G37
Rep Power: 17
Buddy Revell is on a distinguished road
Default

Quote:
Originally Posted by Kyle@STILLEN View Post
We all know that centrifugals are known for having a lag similar to turbo's but he was commenting on how impressed he was with the ability to stand on the throttle at lower RPM to aid the car in rotating through the corner. Which is something that he was very concerned about.
Judging from some of the other posts on this thread, not everyone knows that, LOL.
Buddy Revell is offline   Reply With Quote
Old 02-27-2010, 07:01 AM   #5 (permalink)
A True Z Fanatic
 
370Zsteve's Avatar
 
Join Date: Sep 2009
Location: Gold Coast CT
Posts: 10,599
Drives: 2019 Corvette G.S.
Rep Power: 43
370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute370Zsteve has a reputation beyond repute
Default

Quote:
Originally Posted by Kyle@STILLEN View Post
Today's testing went extremely well!

We had a few goals today and quite a lot of data logging equipment inside the car. We were monitoring a lot of different data points and wanted to put the car through stressful environments, high speed tests, hard launch tests and more to see how everything would perform. We are extremely proud to say that the test could not have been better. Steve was able to really lean on the car and push it hard. We started out with a few simple high speed runs to well over 120+ MPH. Then after that was done we switched over to a tight course to really load up the car and try to get it warm and pushing hard. Then finished up with some really hard driving and let the tires burn!!!

It was really good that we were able to test the supecharger on the automatic gearbox G37. It really proved that the gearbox could handle the power and we were all impressed with its performance. Smooth clean shifts every time and no hang ups at all. Most impressive was the performance during the abuse tests...You'll see the video's on that soon!

At the end of the day Steve commented on how impressed he was with the low-end performance and responsiveness. We all know that centrifugals are known for having a lag similar to turbo's but he was commenting on how impressed he was with the ability to stand on the throttle at lower RPM to aid the car in rotating through the corner. Which is something that he was very concerned about.

I will update this post later tonight with some photos and a short teaser video.

Here is the short teaser video that Josh shot on his Iphone...We know it's not super HD quality but it should be good for now. You can see everyone standing around with cameras and what not we will edit the footage next week when things slow down a little.

User Media - TinyPic - Free Image Hosting, Photo Sharing & Video Hosting
Guys, the vid is very unimpressive. Sorry. Do we have pricing and dynos yet on this beast? I realy need to decide which way I'm going on mods...
__________________
SOLD MY Z MARCH 2018 - another Core OG moves on - new ride 2019 Z Corvette Grand Sport - no mods necessary but already have eyes on HFC and intakes LOL IT NEVER ENDS.
370Zsteve is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Stillen Supercharger estimates??? NewYorkJon34 Forced Induction 454 01-22-2010 11:05 PM
Southern "Winter" preparation? Matt South East Region 1 11-27-2009 05:23 PM
Titan supercharger madmocasin Forced Induction 41 11-09-2009 01:23 AM
Will Stillen Supercharger & G3 intakes Connect? NewYorkJon34 Forced Induction 23 10-31-2009 12:09 AM


All times are GMT -5. The time now is 02:11 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2