Holy ****, that is one insane looking Z my friend. Nice job!!!!

Hahaha little surprise

9:1 compression
Carrillo H rods
Wiseco pistons and other supporting parts

"little" surprise you told me about a month ago....


"Little" ... :gtfo2:

Version 2.0 coming soon :)
Relocated first wastegate and added 2nd 44mm Tial wastegate. I should have everything welded by tomorrow
http://www.the370z.com/members/kukpe...725-162504.jpg

All done.....
http://www.the370z.com/members/kukpe...731-042253.jpg

Pinched wastegate seal and small hole in seal create overboosting
http://www.the370z.com/members/kukpe...728-060310.jpg

New seal
http://www.the370z.com/members/kukpe...730-193539.jpg

When are you going to be at Cars and Coffee? Would love to see this in person. You ever talk with Blake Bylsma, he's in the middle of his turbo build.

http://uploads.tapatalk-cdn.com/2016...6d1578698d.jpg

I just switched mine over to open wastegate damn is it loud

Sent from my Nexus 6P using Tapatalk

My boost is set at 9 psi with a 6% duty cycle at my boost controller. During WOT I'm seeing it hold 9 psi it seems however my boost controller often records a peak of 12.9 psi. Is this normal or could this also be my problem possibly?

Sent from my Nexus 6P using Tapatalk

I wouldn't worry too much about boost spikes if you hold 9psi......
My problem was wastegate location and Pinched seal. I overboosted to 28psi

Holy **** 28 psi that's scary. I'm not on a built motor, that would have destroyed me. But my Ecutek will cut it if it sees 13 psi. I had Hal on dynosty tune it. Did a great job....:)

Sent from my Nexus 6P using Tapatalk

Maybe this weekend. I talk to Blake all the time. His build is nice!

How are your wastegates vacuum hoses connected?

http://uploads.tapatalk-cdn.com/2016...adc29b4e22.jpg

My vacum comes directly from this line on my driver's side charge pipe down to a T by transmission then to both side of both waste gates.

http://uploads.tapatalk-cdn.com/2016...400b769e5d.jpg

The pressure side of my waste gates comes from turbo up to boost control solenoid then down to a T by transmission then to tops of waste gates.

In addition, make sure all unused ports are plugged. I did not plug H2O ports and I am running boosted performance kit V 2.0

Sent from my Nexus 6P using Tapatalk

http://uploads.tapatalk-cdn.com/2016...9c8168e67c.jpg

@ 9.1 psi Ecutek Dynosty tuned. 513 whp 417 wtq. Stock block and internals.

Sent from my Nexus 6P using Tapatalk

Thanks. This is my setup with 4port silinoid