Stillen Air to Air setup

EVOHUNTER · 08-13-2015, 09:58 PM

Quote:

Originally Posted by StillenZ84

So where exactly is this air straightener put? I tried to order 850s as well last week and was told they were no longer made and went with 1000s also.

Right before the Mafs in the 3" section. Straightens the air out so your MAFs can get a good reading. There suppose to improve idle and such. for 20 bucks, i think its a no brainer.

Quote:

Found a few pics of the Stillen Bracket on line and did a real quick job of photoshopping them to just to illustrate the weak area I'm referring to.
If you notice in the picture that has the SC'r attached to the bracket it actually looks like it is solidly designed and constructed.
It is, however, deceiving.
The SC'r itself stands off from the bracket by about a 1/4" or so with a rather stingy spacer --- and to make matters worse, it is only supported part way around.
The SCR is held in space (pun intended) by only the 3 bolts and the small surface area of the spacer.

In the next photo I airbrushed out the SC'r [very quickly and not to scale] just to illustrate the small surface area [highlighted in red - again not to scale] that is being asked to support the SC'r under load.
This is where I feel there is the need for reinforcement in order to reduce the bracket flex.

There is room enough to create a more substantial spacer - extending it's mass to the left [clearing the belts] bolting it to to the main bracket plate with either 3 more bolts or 2 bolts and a locator pin.
This along with EVO's much improved tensioner plate on the other side of the bracket plate should make the bracket super strong.

I'll be the first to kick in another case of beer to EVO's buddy !

Your exactly right, theres basically nothing holding up this charger.

Quote:

Supercharger cog belt being constantly chewed

This design has a MAJOR flaw, He has his brace on his charger. which is fine.
BUT he has the other end of his bracket hooked up to the body!! super big no no..
What happens when your motor moves back and forth from torque lol.

thought that was funny!! i guess he won't need solid motor mounts on one side at least lol

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Custom intake setup -- Stillen G3's, Velocity Stacks, Custom Front Crash Beam, pics	'10Anamoly	Intake/Exhaust	26	02-14-2015 10:59 AM
My new setup :)	Flushnismo	Nissan 370Z Photos / Spyshots / Video / Media Gallery	30	06-29-2012 11:03 AM
[WTB] wtb nismo seats stillen g3 cai stillen headers and stillen exhaust	bloodvayne	Parts for sale (Private Classifieds)	1	12-18-2011 09:25 PM
Stillen Sway bars - 305 rear tires - setup?	FricFrac	Track / Autocross / Drifting / Dragstrip	2	02-15-2011 10:33 AM
Full Stillen Bolt-On Setup - Videos!	RCZ	Intake/Exhaust	114	06-15-2009 04:32 PM