![]() |
Quote:
|
So true! Driving 2 hours one way to a car show tomorrow ;)
|
Quote:
Like the ETS and AMS GTR's. Yea they're 7sec cars, but take one of them on a 6 hour trip tell me if you can find a pumping station on the way back.:bowrofl: |
So I drove to and from the car show today... Put 200+ miles on the car ran a few roll races and even with wheels spinning through 4th and into 5th I had a blast!
|
^ Video's or it never happened!!! :D
|
I'm not going to incriminate myself but Jon parham has some video of a white blur on his phone that's me lol...
|
Quote:
spinning like this?:stirthepot: |
Thank God NO!!! More like a consistent off angle pull then shift then the car would angle the other direction slightly. Granted I am rolling into the throttle... Not mashing the pedal for fear of that happening to me...
|
Man... how do you keep the car straight without twisting the rear end and spinning out? That's what I worry about when I floor it in 1st and 2nd.
|
Quote:
2nd gear the car is sideways and your counter steering while on the throttle... 3rd gear it wants to snap back from the shift and you have to roll on... 4th and 5th it is slightly sideways... Every pull i have done so far in mexico... the car spins the tires through 4th gear... I typically short shift at 5k rpm on some runs depending on the other car to make it even and to keep the car from going too sideways... ran it over the weekend against my buddies 600whp 300zx and even with him jumping the start (lol on 3)... me short shifting with tire spin I caught him in one gear and was passing him... once i caught him and started to pass him I cut the throttle as it was getting way to fast... that and I was running no hood and plastics in the engine bay started to lift and wave hi to him as I passed him. |
why do you have no hood??
|
Do you have it setup for boost level per gear, or have Racelogic TCS installed? How about your gearbox, is it built?
Quote:
|
Lol true because racecar!
my new hood arrived today or so says Jon from Z1... we will see when I call him in a few... Only an upgraded clutch and flywheel at the moment. The OEM gears are perfectly fine for these power levels suprisingly... may go down to a lower Final drive to get better top end and improve drive-ability. 1st gear 60mph anyone hehehe I am still awaiting my traction control unit from GTM. We were missing the wiring harness and Zeliminator was kind enough to loan his for a new one to be made for me! |
Awesome
|
Quote:
|
All times are GMT -5. The time now is 10:52 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2