Shaved door handles

JoeD · 10-20-2009, 08:37 PM

Quote:

Originally Posted by 370ZBLACK09

Is there any new news on the GTR retro fit and Shaved options?

I don't think anyone has been able to grasp the true cost of retrofitting GTR door-handles. Not only will you have to cut/mold the doors, but fab up the actual mechanisms for everything to work properly. You're looking at least $2K in labor alone, not including the handles from Nissan. Shaving, on the other hand, should be no different than on any other car as there are pre-fabbed kits available through the aftermarket.

Still...you must really hate the factory door-handles to go through all the headache necessary to get rid of them. I say leave the shaved-handles for the mini-trucks and lowriders.

bullitt5897 · 10-20-2009, 09:55 PM

Quote:

Originally Posted by JoeD

I don't think anyone has been able to grasp the true cost of retrofitting GTR door-handles. Not only will you have to cut/mold the doors, but fab up the actual mechanisms for everything to work properly. You're looking at least $2K in labor alone, not including the handles from Nissan. Shaving, on the other hand, should be no different than on any other car as there are pre-fabbed kits available through the aftermarket.

Still...you must really hate the factory door-handles to go through all the headache necessary to get rid of them. I say leave the shaved-handles for the mini-trucks and lowriders.

JoeD I understand this is a forum and you have the right to voice your opinion but jeeze man you have no clue what you are talking about. I have researched the parts it will take to do the retro fit and the costs are a lil over $1k to do them. You do not have to make all kinds of crazy custom parts maybe a mount or two but not a whole lot. its as simple as buying the inner door mechanism/actuators for a gtr plus the handle assemblies... thats it! Other than that the cost of getting them installed is close to the same as shaved door handles. Shaved doors is well under the $750 mark and looks very clean.

back on to the other ideas.

Shoot I like the idea of the corvettes but the problem comes down to modifying the rear quarter panel and the door to do it... mucho expensivo my friends! lol but its a nice concept and it would look good too!

JoeD · 10-20-2009, 10:16 PM

Quote:

Originally Posted by bullitt5897

JoeD I understand this is a forum and you have the right to voice your opinion but jeeze man you have no clue what you are talking about. I have researched the parts it will take to do the retro fit and the costs are a lil over $1k to do them. You do not have to make all kinds of crazy custom parts maybe a mount or two but not a whole lot. its as simple as buying the inner door mechanism/actuators for a gtr plus the handle assemblies... thats it! Other than that the cost of getting them installed is close to the same as shaved door handles. Shaved doors is well under the $750 mark and looks very clean.

LOL...ok. Do it, then report back to us and let us know how it goes.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
door handles	polarity	Exterior & Interior	18	09-19-2009 07:52 PM
carbon fiber door handles	slippy	Exterior & Interior	3	09-17-2009 03:54 AM
Handles on the door..Polish?	209Z	Exterior & Interior	10	06-08-2009 12:09 AM
Door handles.	Forumite	Nissan 370Z General Discussions	17	05-20-2009 07:07 PM
Door handles	ATC5079	Exterior & Interior	15	05-13-2009 07:50 PM