Page 51 states -
BCM performs the high flasher operation (fail-safe) if any bulb or harness of the turn signal lamp circuit is open. Note: Turn signal lamp blinks at normal speed when using hazard warning lamp. |
It is the fuse in the IDPM it is not labeled properly mine blew and I changed it and it all good.
|
Quote:
|
Have you checked the connections? I mean its worth a shot... maybe you pullled a wire loose when you were unpluging from the harness I would check to see if any wires wiggle a little to much lol.......
|
I don't know which one is 52, but I pulled every 10A fuse and they are all fine in there.
http://imageshack.us/a/img838/6762/imagebjoc.jpg |
Time to double check the wiring I guess.
|
new harnesses are less than 40 each, so I'm going to just replace them and see what happens. If that doesn't do it, I don't really need them anyway.
|
Quote:
|
Quote:
|
I had a similar issue it was a fuse. My issue was my passenger side headlight TURN SIGNAL and LOW BEAM were not working. I troubleshooted it by installing the defective light into the opposite side harness WHICH IT WORKED. So after taking the word of a mechanic saying the fuses where fine, I discovered that one fuse was burned out. The fuse on the right side, 4th from the bottom controls both the TURN SIGNAL and LOW BEAM. Once replaced, both my turn signal and low beam worked again :)
Hopefully that helps, |
my low and high beams work fine, as do the two lower running bulbs, just not the turnsignals
|
Did your issue ever get fixed? How did you do it? I am running into the same issue...
|
All times are GMT -5. The time now is 05:14 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2