Rattling Sound

buenor · 07-02-2012, 01:11 PM

Hello Shadezz

The "repair" seems to have done the trick. What I did was:
- Took out the screws that hold the top cover. I only took out the ones behind the steering wheel. Took out one at the time, since I didn't want to go through the whole thing about taking out the steering wheel.
- Jiggled the top cover a bit and sat it back in position. Sorry for the highly technical terminology

Of course I couldn't take it out (those two bolts are not the only ones holding everything in place). But I made sure that if fit properly since I had assume that the rattle was generated by the cover not fitting correctly.
- Reinstalled the screws, make sure they are tightened properly. I didn't force them or anything. Mine were originally not very tight when i took them out.

I will post if anything changes.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Annoying Rattling	PG370	Intake/Exhaust	32	06-23-2016 08:56 PM
Rattling exhaust?	roy'sz	Intake/Exhaust	0	04-13-2012 12:36 PM
Windshield Replaced Now Rattling	ddvette9	Exterior & Interior	4	09-07-2011 05:01 PM
Rattling noise	bitemarks	Nissan 370Z General Discussions	13	08-19-2011 01:44 PM
Rattling in the rear??? (interior)	CFZ	Exterior & Interior	3	08-12-2011 04:42 PM

07-02-2012, 01:11 PM	#1 (permalink)
buenor Base Member Join Date: Jun 2012 Location: Florida Posts: 25 Drives: 370z Touring/Sport Rep Power: 14	Hello Shadezz The "repair" seems to have done the trick. What I did was: - Took out the screws that hold the top cover. I only took out the ones behind the steering wheel. Took out one at the time, since I didn't want to go through the whole thing about taking out the steering wheel. - Jiggled the top cover a bit and sat it back in position. Sorry for the highly technical terminology Of course I couldn't take it out (those two bolts are not the only ones holding everything in place). But I made sure that if fit properly since I had assume that the rattle was generated by the cover not fitting correctly. - Reinstalled the screws, make sure they are tightened properly. I didn't force them or anything. Mine were originally not very tight when i took them out. I will post if anything changes.