|
If the Nismo has an Homelink mirror, you can use invisicord for easy wiring! But as far as tucking it in its easy, and use a plastic panel removing tool
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
09-04-2010, 06:46 PM
|
#1 (permalink) |
|
Enthusiast Member
Join Date: Mar 2009
Location: Irving, TX
Posts: 268
Drives: 97 Civic Ex Coupe
Rep Power: 17  |
If the Nismo has an Homelink mirror, you can use invisicord for easy wiring!
But as far as tucking it in its easy, and use a plastic panel removing tool to hide the wire. Its held on by clips and just remove a part of the door seal to route to the fusebox! Look at Homelink mirror installation DIY, to get a feel for how to route the wiring, its very similar! |
|
|
|
09-04-2010, 09:55 PM
|
#2 (permalink) |
|
Base Member
 Join Date: Aug 2010
Location: O'Fallon, Illinois
Posts: 31
Drives: 2010 370Z Touring
Rep Power: 16 |
 Elm Tx, I just hooked up my V1 today directly into the fuse box. I looked for several switched circuits before I found one that worked. I used the 10A Audio/Mirror switched circuit (marked as such on the back of the fuse cover). Now when car is turned on to acc or run my V1 is on and it goes off when I turn off the ignition. Hope this helps! 
|
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hard wired V1 Radar detector power problem | tjlazer | Nissan 370Z General Discussions | 7 | 01-29-2011 10:04 AM |
| Radar Detector | jacknismo | New Forum Member | 5 | 06-16-2010 08:13 AM |
| radar detector | allenhhp | Exterior & Interior | 31 | 06-02-2010 12:42 PM |
| Radar Detector | Sunsational04 | The Lounge (Off Topic) | 60 | 11-19-2009 02:45 PM |
| Request: DIY Radar Detector Hardwire w/out Power Rear View Mirrors | Viera | DIY Section (Do-It-Yourself) | 2 | 06-13-2009 09:53 PM |
Hybrid Mode
