![]() |
Originally Posted by shadow2k How exactly did you do this? i bought large washers and M10X50 1.25pitch screws (2pcs) to raise the back end of the seat. This is modshack's
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#11 (permalink) |
A True Z Fanatic
![]() Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
i bought large washers and M10X50 1.25pitch screws (2pcs) to raise the back end of the seat. This is modshack's suggestion and it worked out great.
the front screws you just loosen a bit when you install the rear spacers and new bolts, and then tighten down. i think it was 36lbs/ft torque on all 4 bolts. check the service manual. then you can use your seat adjustments to get the tilt of your seat bottom to your preference. it turned out perfect for me. ![]() thanks again, modshack! ![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anyway to take apart side view mirrors? | nextbesthing | Nissan 370Z General Discussions | 0 | 04-08-2010 07:56 PM |
Side mirrors | Calvin | Exterior & Interior | 5 | 03-13-2010 11:56 PM |
Rear View Mirrors | 370er | Australia/New Zealand | 2 | 11-25-2009 08:19 PM |
Request: DIY Radar Detector Hardwire w/out Power Rear View Mirrors | Viera | DIY Section (Do-It-Yourself) | 2 | 06-13-2009 09:53 PM |
ZELE Carbon Fiber Side View Mirrors for 370Z Z34 01.07.09 | AK370Z | Nissan 370Z Photos / Spyshots / Video / Media Gallery | 24 | 04-22-2009 05:43 PM |