|
Originally Posted by JakeZ34 Hey Kenchen I can't seem to privately message you so I'm going to post this here, what are the parts needed to make this holder? Can
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-29-2010, 02:35 PM
|
#32 (permalink) | |
|
A True Z Fanatic
 Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141522   |
Quote:
 messages when i post some joke about them.  as for the bracket you can basically use any metal strip and bend it into shape. I used a small hinge like the one modshack used (can be had at art stores) and a tapping screw. For the ball joint i cut off the arm from the garmin suction cup holder and screwed 3-4 small tapping screws throught the bracket. i think amazon sells just the ball joint with adhesive so you might want to run a search over there.  the joint is pretty tight so you'll probably need to reinforce the adhesive with screws.at the end i wrapped the bracket with DiNoc CF wrap. looks very clean.  GL! 
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| the370Z.com License Plate Holder??? | flashburn | The370Z.com Feedback, Suggestions & Questions | 30 | 05-02-2010 09:59 PM |
| scratched cup holder chrome | dudafunk | Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs | 10 | 03-08-2010 08:53 PM |
| Front License Plate tow-hook holder | Spartan 1771 | Exterior & Interior | 21 | 01-19-2010 06:46 PM |
| Need rear license plate holder advice... | Diversion | Exterior & Interior | 14 | 05-29-2009 02:12 PM |
| Tow Hook License Plate Holder No Drilling | YamahaR6 | Exterior & Interior | 5 | 03-31-2009 03:02 PM |
Threaded Mode
